Loading ...
Loading ...
Loading ...
Faults and what to do about them en
45
Faults and what to do about them
E:35
alternating with
-10 (Suitable for
special models)
There is water in the base trough, the appliance is leaking. Turn off
the tap. Call customer services.
H:95
alternating with
End
when programme
is finished
No water detected in drying phase, may get bad drying result.
~ "Filter in the water supply is blocked" on page 42
H:32
alternating with
End
when programme
is finished
The unbalanced load detection system has interrupted the spin
cycle because the laundry is unevenly distributed. Distribute small
and large items of laundry evenly in the drum.
Other displays Turn the programme selector to Off, wait for five seconds and
then switch it on again. If the display appears again, call customer
services.
Faults Cause/Remedy
Water is leaking from
the appliance.
■ Attach the drain hose correctly or replace it.
■ Tighten the screw fitting on the supply hose.
The door cannot be
opened.
■ - - - (Rinse hold = no final drain) is activated (depending on
the module). Continue the programme by selecting Spin
and pressing A Start/Pause .
■ The temperature in drum is too high to open the door.
■ The safety function is activated. Stop the programme?
■ The water level in drum is too high.
■ Can the door only be opened by the emergency release?
~ "Emergency release" on page 43
The appliance is not
filling with water.
Detergent is not
being dispensed.
■ Programme does not start?
■ Is the tap turned on?
■ Could the filter in the water supply be blocked?
~ "Filter in the water supply is blocked" on page 42
Note: . If an additional water filter has been installed
(depending on the model), check for contaminants and
clean if required ~ separate installation and cleaning
instruction for water filter.
■ Is the supply hose kinked or trapped?
Display Cause/Remedy
Loading ...
Loading ...
Loading ...