Loading ...
Loading ...
Loading ...
• 10 •
14. TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Low or no output
voltage.
Poor contact at terminals.
Using incorrect type of voltmeter
to test output voltage.
Disconnect and reconnect the 12V
connections.
Use a true RMS reading meter.
Red LED is lit. The battery voltage is below
10.5 volts.
The equipment being operated is
drawing too much power.
The converter is too hot (thermal
shutdown).
Recharge or replace the battery.
Use a higher capacity converter; do
not use with this equipment.
Allow converter to cool. Check for
adequate ventilation. Reduce the
load on the converter to the rated
continuous power output.
Device does not
operate properly
when rst connected
to the converter.
The converter may not have
the required capacity to operate
the device.
Turn the converter switch OFF and
ON, to reset the converter.
15. SPECIFICATIONS
PC-2000
Continuous output power ........................................................................................2000 W
Surge output power (0.1 second) ...........................................................................4000 W
Nominal input voltage ................................................................................. 12.8-13.2 VDC
Nominal output voltage .................................................................................. 110-125 VAC
Operating input voltage range .................................................................... 10.0-15.0 VDC
Output frequency .............................................................................................60 Hz±3 Hz
Maximum no load current draw (at nominal input voltage) ....................................1.5 ADC
Full load input current ...........................................................................................180 ADC
Maximum efciency .....................................................................................................90%
Input overvoltage shutdown (at no load) .......................................................... 16±0.5VDC
Input undervoltage shutdown (at no load) .................................................... 10.0±0.5VDC
Input undervoltage warning (buzzer) ............................................................ 10.5±0.5VDC
Output power overload shutdown level ....................................................... 2200W±200 W
Output waveform...................................................................................Modied sine wave
AC receptacles.............................................................................. Three, NEMA 5-15 USA
USB port ...........................................................................................................One, 5V/2A
Internal fuses ................................................................................ 8x30A/250V, blade fuse
Overload protection....................................................................................................... Yes
Battery cables ................................................................................. Two black and two red
Ground wire ....................................................................................................... One green
Loading ...
Loading ...
Loading ...