Craftsman 24724030 twin rear bagger

User Manual - Page 12

For 24724030.

PDF File Manual, 20 pages, Download pdf file

Loading ...
Loading ...
Loading ...
8,
Install both bag assemblies onto the bag support brackets
by inserting the front edge in first, as seen in 1 of Fig.
4-16, and setting the back edge down until it fits into the
assembly (2).
Figure 4-16
9. Install one of the rubber chute straps onto the chute elbow
using one of the supplied clevis pins (711-05063), washer (736-
0204) and Bow-tie cotter pins (714-04040) from hardware
pack 689-00092B. See Fig. 4-17. Secure the end of the strap
utilizing the hole furthest from the end, insert the torsion
spring hook (732-04510A) into the other end.
10. Install the deck mounting pin (711-05049) up into the chute
elbow using two flat washers (736-0176) from hardware pack
689-00092B and secure with a flange lock nut (712-3027), as
seen in Fig. 4-17.
11. Install the shoulder bolt (738-0754) into the chute elbow
from the top side and secure inside the chute elbow using
a flange lock nut (712-04063) from the same hardware pack
(689-00092B). See Fig. 4-17.
Figure 447
12. Install a grass-catcher pin (911-04069) from hardware pack
689-00092B into the hole provided in the upper portion of the
chute elbow and secure with a flange lock nut (712-3027). See
Fig. 4-18.
f
13.
14.
Figure 4-18
Install the other rubber strap onto the chute tube extension
using the remaining clevis pin, flat washer and bow-tie cotter
pin from hardware pack 689-00092B. Attach the end with the
hole closest to the end of the strap, as seen in Fig. 4-19. This
will make it easier to grab onto the strap to pull, stretch and
hook onto the grass-catcher pin previously installed on the
chute elbow in the previous step.
Figure 449
With the tractor's discharge chute raised up and held open,
install the chute elbow over the chute opening by placing
the deck mounting pin in the hole provided, as seen in Fig.
4-20, then secure the elbow to the deck by hooking the
retainer strap torsion spring hook into the hole provided in
the flange on the front-side of the cutting deck as seen in
Fig. 4-21.
12 [ SECTION 4 -- ASSEMBLY& INSTALLATION
Loading ...
Loading ...
Loading ...