Loading ...
Loading ...
Loading ...
5_
6_
Figure 4=11
Install the bagger cover onto the bag support assembly, as
seen in Fig. 4-12. The plastic cover goes inside of the two
mounting tabs.
Figure 4=12
Slide the hinge pin into the hole located on the mounting
tab, as in Fig. 4-13. Use the cut-out window (See inset in
Fig. 4-13) to line up the hinge pin on the other side and
push pin all the way in until it reaches the end-stop. At this
point the pin clips into place and is secured by a tab in the
bagger cover. See Fig. 4-14.
Figure 4=13
n'_
Figure 4=14
7. Open Hood by pushing in on the rear, right-side tab with
your right hand, as seen in 1 of Fig. 4-15, and lifting the cover
with your left hand in the center rear of the bagger cover, 2.
Figure 4=15
SECTION 4 -- ASSEMBLY& INSTALLATION 11
Loading ...
Loading ...
Loading ...