Troy-Bilt 020208 Pressure Washer

User Manual - Page 8

For 020208.

PDF File Manual, 36 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
Section 3: Assembly
Connect Hose and Water Supply to
[HPORTANT:To avoid pump damage,you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
I. Attach one end of hgh pressure hose to high pressure
outlet on pump (Figure 7).Tighten by hand.
2,
Attach other end of hose to base of spray gun
(Figure 8).Tighten by hand.
ere
Before connecting garden hose to water inlet, inspect
inlet screen (Figure 9). Clean screen if it contains
debris, replace if damaged. DO NOT RUN PRESSURE
WASHER IF SCREEN IS DAHAGED.
4. Run water through garden hose for 30 seconds to
clean out any debris.Turn off water.
IMPORTANT: DO NOT siphon standing water for the
water supply.Use ONLY cold water (less than IO0°F).
5. Connect garden hose (not to exceed 50 feet in length)
to water inlet.Tighten by hand (Figure 9).
Damage to equipment resulting from f_iJureto follow this
instruction will void warrantT;
6. Turn ON water and squeeze trigger on spray gun to
purge pump system of air and impurities.
WANNING
Always wear eye protection when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate eye protection,
Checklist Before Stardn ine
Review the unit's assembly to confirm you have performed
all of the following:
I. klake sure handle is in place and secure.
2. Check that oil has been added to proper level in
engine crankcase.
3. Add proper fuel to fuel tank.
4. Check for properly attached hose connections.
5. Check to make sure there are no kinks, cuts, or
damage to high pressure hose.
6. Provide a proper water supply at an adequate flow.
7. Be sure to read "Safety Rules" and "HowTo UseYour
Pressure _A/asher" before using pressure washer.
O
Loading ...
Loading ...
Loading ...