Loading ...
Loading ...
Loading ...
Storage
PREPAPJNG THE fJN[T
FOP, STORAGE
Water shouldnot remain inthe unitforlongperiodsof
time.Sedimentsor mineralscan depositon pump partsand
"freeze" pump action. If you do not plan to use the pressure
washer for more than 30 days, follow this procedure:
I. Flush detergent siphoning tube by placing filter into a
pail of dean water while running pressure washer in
low pressure mode. Flush for one to two minutes.
2. Shut off engine and let it cool, then remove high
pressure and garden hoses. Disconnect spark phg wire
from spark plug.
3. Empty pump of liquids by pulling engine recoil handle
about 6 times.This should remove most liquid in pump.
4. Use pump saver to prevent corrosion build up and
freezing of pump.
5. Store unit in a ciean_ dry area.
Protecting the Pump
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver to treat pump.This
prevents freeze damage and lubricates pistons and seals.
NOTE: PumpSaver is available as an optional accessory, it is
not included with the pressure washer. Contact the nearest
authorized service center or visit your local Lowe's store to
purchase PumpSaver.
• Failure to do so will permanently damage your pump and
render your unit inoperable,
• Freeze damage is not covered under warranty.
CAUTION
Always wear eye protection when using PumpSaver.
To use PumpSaver, make sure the pressure washer is
turned off and disconnected from supply water. Read and
follow all instructions and warnings given on the PumpSaver
container.
NOTE: PumpSaver will drip from pump after treatment
and will stain wood and concrete.
NOTE: If PumpSaver is not available, draw RV antifreeze
(non-alcohol) into the pump by pouring the solution into a
3°foot section of garden hose connected to inlet adapter
and pulling recoil handle twice.
STORING THE ENGINE
See the engine owner's manual for instructions on how to
properly prepare the engine for storage.
Loading ...
Loading ...
Loading ...