Loading ...
Loading ...
Loading ...
Section 3: Assembly
Z Secure tray to handle with serf tapping screws using a
#2 phillips screwdriver. Ensure screws are tight but not
crushing plastic accessory tray.
3. Place handle assembly onto handle supports connected
to main unit. Hake sure holes in handle align with holes
on handle supports (Figure 2).
7. Pinch chemical hose and slide it into metal clip as
shown in Figure 5.
HandHe
Supports
NOTE: It may be necessary to move the handHe supports
from side to side in order to aHignthe handHeso it wHHsHide
over the handle supports.
4. [nsert"U' boHt through hoHe on right side of handle
(viewing from rear of unit) and attach plastic [<nob.
Tighten the knob by hand (Figure 3).
f
f
i
i
f
#
i
5. Insert carriage bolt through left side hole from outside
of unit and attach a plastic knob from inside of unit
(viewing unit from rear).Tighten by hand (Figure 3).
6. Insert the "J" hook into the second from the [eft slot in
the accessory tray (Figure 4).
8.
Tilt unit up by handle and attach metal clip to rib on
center underside of accessory tray (Figure 6). Slide
chemical hose through metal dip so that it is tight but
not kinked.
Add Ens[ne Oil and Fuel
° Place pressure washer on a [eve[ surface.
, Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
• Refer to engine manual for oil and fuel fill information,
, Damage to equipment resulting from failure to follow this
instruction will void w,arranty;
NOTE: Check oil often during engine break-in. Refer to
engine owner's manual for recommendations,
0
Loading ...
Loading ...
Loading ...