GE - General Electric PSS25NGMBCC GE refrigerator - m series

User Manual - Page 22

For PSS25NGMBCC.

PDF File Manual, 115 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Removingand replacing the doors.
When installing or moving the refrigerator, the doors may need to be removed in order to fit the refrigerator
through a doorway.
Removing the Doors
Make sure the doors are closed and the refrigerator is
unplugged.
0 Disconnect water line and wiring harness.
Near the lower hinoe_ on the fl'eezer side, push in on the
collm_ at each end ot the coupling, and pull the water
line robing fl'on/the coupling. _Mso, (liscmmect wiring
harness. Pull the water line and the harness through the
lower rail.
0 Remove the hinge covers and the hinges.
In order to access the hinges, the hinge ('ove_ need to be
removed. Remove the cover by grasping it on the sides,
near the back of the covei: Push back on the cover and
lift up at the back, then the front.
/VOTE:DO NOTuse a screwdriver to remove the cover BECAREFUL
not to break the rear retaining tab onthe hinge cover Removethe
hlbges uslbga TorxT-20.
0 Remove the doors.
(:arefhllv rotate the door to 90? (;uiding the disconnected
water line and wiring harness, lift the door straight up.
NOTE: Not li@bg the door straight up may damage the bottom hinge.
Piece doors on a protectedsurface.
/VOTE:Be careful not to pinch the water tubing and the wire harness
at thebottom of the door
/VOTE:Donot allow the connectorto contact the floor Hardcontact
can damage the connector See "Replacingthe Doors."
Replacing the Doors
0 Place doors on bottom hinges.
X'_ith the door at 9(F lower the door straight down onto
the bottom hinge. Careflflly close the do(n:
/VOTE:Not lowenbg the door straight down onto thebottom hinge
may damage the hlbge.
/VOTE:Do not allow the connectorto contact the floor Hardcontact
can damage the connector
0 Replace top hinges and hinge covers.
Reinstall the top hinges using a Torx T-20. Replace the
hinge cove_. If the dom_ are not level, a@_st the bottom
right hinge with a 7/16" open ended wrench.
_) Reconnect water line and wiring harness.
Insert water tubing back into coupling, making sure the
tubing is pushed liar enough into the coupling so that you
no longer see the mark on the robing. Recmmect the
wiring harness.
0 Turn on the water supply and plug the refrigerator hack in.
WireHarness%
-- HingeCover
I ' _ Door
_ HingePin
Connector
23
Loading ...
Loading ...
Loading ...