Loading ...
Loading ...
Loading ...
Installingand removingpreviouslyinstalled decoratorpanels.
Read these instructions completely and carefully.
Removing the Handles
In order to remove the decorator panels and replace
with new panels you need to remove the handles.
A 520 Torxdriver is neede_
I,oosen and reinove tile 2 sci'e_vs in tile
Top Trim.
O I,oosen and remove tile 2 scre_vs in tile
bracket that attaches tile Handle to tile
top of tile Doo_:
O (;rip tile Handle fired) and slide upwards,
The kexhole slots on the Handle slide off
tile bu[tons on tile door.
0 Open tile door and slide out tile decorator
panels.
TopTrimScrews
BracketScrews
Bracket
>Slots
Inserting the Door Panels
Before installing the decorator panels, make sure they have been routed out in the proper areas as shown/n the
beginmng of this section. Slide in the panels to perform a toal fit before fastemng down the Hand& and Top Trim.
Installing the Handles
Oncethe pane& are fitted pmperly, install the Handle and Top Trim.
0 Slide tile ke)hole slots on tile Handle down
onto tile buttons mounted to tile fi_ce of tile
doo_: Slide the Handle dowmvard tmfil the
bracket at tile top ot tile Handle fits flush on
the top of the door.
Replace tile two scrm_:s in tile bracket that
attach tile Handle to the top of tile Door and
tighten tile scrm_:s to 45 in-lbs torque.
O Replace tile Top Trim making sure it fits over
the Side Trim and that the locating tabs fit the
inside of the Handle profile.
O Replace tile Top Trim screws and tighten to
30 in-lbs torque,
22
Loading ...
Loading ...
Loading ...