Loading ...
Loading ...
Loading ...
w
LET'S KEEP GOING...IT'S GETTING EASIER, WE HOPE.
7
NOW WE'RE GETTING INTO
THE ACTUAL INSTALLATION.
SEPARATE THE PARTS IN
THE MOUNTING ASSEMBLY.
Mounting _,_ Lower
Assembly / _Mounting "
Ring
First, remove the mounting assembly
from the dower mounting ring, Holding
the mounting assembly with one hand,
insert your wrenchette or screwdriver
inlo one of the lugs of the tower moun-
ting ring end turn it to the Jeff
(counterclockwise) with your other
hand
Then loosen the screws on the moun-
ting assembly until they are just level
with the surface of the mounting ring.
Now, use a screwdriver to pry off the
snap ring
ID
Groove '_
SineSleeve
• _.%°"°g
The assembly will now come apart. Set
it aside and move to the next step.
NEXT, LET'S ATTACH THE
UPPER MOUNTING
ASSEMBLY.
First, working from under the sink, slip the
fiber gasket and next the metal back-up
ring (flat side up} up and over the sink
sleeve,
B,
Holdthe fiber gasketand metal back- UP
ring in place with one hand and place
the mounting ringwithits three screws onto
the sink sleeve.
rC_
Now, push the fiber gasket, metal back-_.
ring and the mounting ring further up onthe
sink sleeve. Slide the snapring onto the sink
sleeve until it POps into place in the groove
:_nthe sleeve.
T_hten the three mounting screws with
your screwdriver until the whole mounting
assembly te seated evenly and t_ghtly
againstthe sink.
8
APPLY PUTTY TO THE
SINK SLEEVE.
A=,,
Make a fat snake of "plumber's"
patty by rolling it between your
hands.
B.
Apply this roll under the rim of the
sinksteeve
Then, place the sink sleeve into the
sink drain hole and push down
gently but firmly to make sure it sits
evenly in the putty.
0 TURN YOUR NEW
DISPOSER UPSIDE
DOWN AND REMOVE
THE ELECTRICAL
PLATE FROM THE DISPOSER SO
YOU CAN SEE THE WIRING AND
THE GROUND SCREW. THE BOTTOM
OF YOUR DISPOSER WILL LOOK
LIKE THE ONES SHOWN IN 'A' OR 'B'.
(Start here if you are replacing a disposer with the same mouni_ng.)
Remove the electrical plate lrom the bottom of the disposer and pull out the
black and white electrical wires The green ground screw is also under this
plate.
BLrrTON
Loading ...
Loading ...
Loading ...