Loading ...
Loading ...
Loading ...
i
i
Installation Instructions
= = = = i
ISTEP 71 ECONOMY WATER USAGE
The pressure sw tch sset n the factory for the high
water level and usage,
Tochange setting from high water level to medium or
low:
WARNING - MA*E
SUREWASHER IS UNPLUGGED FROM ELECTRICAL
OUTLET.
• Remove 4 torx screws from back of control panel
and lay control panel front on cover.
Remove
. From the front, move white plastic cam on pressure
switch in the clockwise position with your finger
[STEP 9] SPECIAL INSTRUCTIONS
COVERSECURITYLOCKINSTALLATION
Washer cover is designed to accept stud type lock
as shown below,
5/16"-t8 Thread
518"
!-*-L_f
I_- i-1/16"-"-I %arVbw
CamLockAvailable.__
FromGreenwald
11mF
Part#8-I222
To install lock:
• Remove plastic insert infront of cover,
•Install the lock washer on the lock shaft and locate
so that the lock can be engaged in acounterclock-
wise direction.
• Insert lock mechanism into cover opening and
tighten until snug. (Overtightening may damage
painted surfaces.)
until it clicks over into the medium or low water
position, (See illustration below,)
RotaLe
kwise
i iJ i
i ii i i i i
ISTEP 81 ELECTRICAL CONNECTION
CAUTION -BEFORE
PLUGGING INAPPLIANCE, READ ELECTRICALAND
PLUMBING REQUIREMENTSAND CHECKLIST,
Plug electrical power cord into a properly grounded
wall outlet.
• Install cam and tighten until snug,
ACCESSDOORLOCKINSTALLATION
Toremove the access door retainer before installing
a lock, place the door over a wood block with at/2"
hole drilled in it and tap end of screw lightly with a
hammer.
_-Wood
Bock
Nut
LockWasher
_) -SpringWasher
Nut_,,._l,._am
Loading ...