Loading ...
Loading ...
Installation Instructions
i i i
ii i i
rSTEP11 PREPARE WASHER ISTEP 3t ATTACH DRAIN HOSE
FOR INSTALLATION TO WASHER
•Grasp shipping rod on MoveWasherClose • Make certain all installation items have been
lower right side (it has a toFinalPosition removed from the washer basket.
tag or strap), and pull Shipping •IMPORTANT'.Remove red plug , Grommet
rod straight out and Roe from drain hose port. _i_ t /iI,__
discard, NOTE',Some water may be
present, this is normal, Plug
_gor . Locate plastic drain hose
adapter, Place hose clamp over
drain hose on& Insert drain
hose adapter into bent end of
drain hose, Position clamp to
Remove inner pack _ Inner secure hose adapter to drain
• hose, Push plastic hose clamp over hose adapter into
and installation _ Pack grooved slot.
NOTE:This requires some force to install, and has aaccessories from Partsand
under lid, Drain hose is _[_. _ Water positive click when forced into port. A positive click
in washer basket, __ Hoses(2) will ensure that the proper amount of force has been
applied,
[!,:_/1_ \ Drain Hose Drain
Ti Hose Adapter Hose
Screws Port
t
• Move washer to | Drain
installation location for _ Hose
remaining hose and
electrical preparation.
i i i ii iii i ]
ii] i i
ISTEP21ATTACH FILL HOSES
• Push plastic conical end of drain hose adapter into
TO WASHER washer drain hose port. Insert two screws found in
insert rubber washers into both ends of each fill installation pack, and drive screws to mount drain
hose. Attach fill hose marked HOTto hot washer inlet hose to washer,
valve. Attach fill hose marked COLDto cold washer AntisiphanCip
inlet valve. Couplings should be hand
tightened plus 112turn with pliers, _,_!Cab!e tie
HandTightenPlus 3C)"_'_ : , ]
1/2TurnwithPliers Iti_r_ /
ColdWater_ Less
l-lose\ __ Hose _/ _aa..._ _
Cabl_ Drain
Hose
NOTE:tf drain hose facility does not meet the 30"
minimum standpipe height requirement, thread drain
Water Washers ElectricalCord hose through supplied antisiphon clip and mount to
Hose
cabinet back as shown. Mount antisiphon clip by
...... inserting top clip into top mounting hole and snap
second clip into position.
, ii
Loading ...
Loading ...
Loading ...