GE - General Electric WNCK2050D0WC GE washer

User Manual - Page 4

For WNCK2050D0WC.

PDF File Manual, 6 pages, Download pdf file

Loading ...
Loading ...
Loading ...
]1 , lu
Installation Instructions
i ii i i i
iiii
ISTEP 41 ADJUST LEVELING LEGS
•Ptace level on front top edge of washer,
, Adjust front leveling legs until washer is level from
side-to-side. Remove level,
Tilt washer forward (pivot on front legs) 4to 6
inches, This action will set rear leg adjustments to
correspond to front setting.
Gently set washer back down,
m
ide
ont
LevelingLegs
TiltWasherForward
4to6 Inchesto Set
RearLegAdjustment.
ISTEP 5J INSTALL FILL HOSES
Be sure water supply lines have been thoroughly
flushed,
Move washer to final location, DO NOT let fill or
drain hoses drag and get under washer.
CAUTION - BESUREFILL
HOSESAREFIRMLY SECUREDTO FAUCETS.
Determine which is the HOT water line before
attaching fill hoses to faucets. Traditionally, HOT
faucet is on the left. Be sure rubber washers are in
both ends of washer flit hoses, Connect hose from
inlet valve on washer (marked HOT)to hot faucet
and connect hose from COLDinlet valve to cold
faucet. Couplings should be hand tightened plus
t/2 turn with pliers.
HandTightenPius
1/2TurnwithPliers
,o
t _ scr=_ _. Cold
Water.. L=IRubber"Water
Hose "-_ wa_ Hose
ii
i
ii
!STEP 61 INSTALL DRAIN HOSE
Insert one end of aluminum drain nozzle into
standpipe,
Slip or cut wire wrap back approximately 2" below
top of standpipe,
Cut drain hosejust below standpipe, Place silver
hose clamp over black drain hose end,
Insert drain nozzle into end of drain hose, and
position clamp to secure drain nozzle to drain hose,
Install drain hose in drain facility and secure with
cable tie strap provided as illustrated.
Secureto
Hose
Drain
CableTie Hose
NOTE:Drain hose nozzle may be shortened if original
length prevents full insertion into drain facility.
CAUTION - BESURE
DRAIN HOSEIS TAPEDORSECUREDTOSTANDPIPE
OROTHERDRAIN FACILITY.
NOTE:Water may be drained into a standpipe, The
discharge height must not be less than 30 inches, nor
more than 8 feet above base or washer. Standpipe
must be 1-1/2" minimum inside diameter and must be
open to atmosphere.
4
Loading ...
Loading ...