Loading ...
Loading ...
3
An adapter is included that allows 12” flexible ducting to
be connected to the inlet. It is stored on the unit’s side.
Flex duct is pushed through the adapter center with the
adapter hooking tabs facing away from duct; (see figure
4).
Figure 4
The spiral wire passes from one side of the adapter to
the other via the notch on the hole edge; (see figure 5).
Figure 5
The adapter and duct are positioned on the unit top with
the four tabs placed into the slots. The adapter is then
twisted counterclockwise to lock it in place; see figures 6
and 7.
Figure 6
Figure 7
2.5b Outlet Ducting
Three rectangular wire-form collars are supplied that will
allow round lay-flat plastic ducts to be attached to the
Phoenix Guardian outlet. The two small collars are made
for 10” lay-flat duct; the large one is for 14”. Lay-flat
plastic ducting is available from Therma-Stor.
To attach ducting to a collar, remove the collar from the
unit by loosening the two wing knobs above the collars
and sliding the collar out. Put the plastic duct end
through the collar center from the front. Fold the duct end
outward so that it overlaps the outside of the collar by
several inches.
The same adapter that allows 12” flexible ducting to be
connected to the inlet can be used to connect 12” flexible
duct to the outlet. It is stored on the unit’s side. Flex duct
is pushed through the adapter center with the adapter
hooking tabs facing toward the duct, (see figure 8 and 5).
www.sylvane.com 1-800-934-9194
Loading ...
Loading ...
Loading ...