Loading ...
Loading ...
Loading ...
iiiiiiiiiii iii!iili iilii!i
iiiiiiii ii/
/nsta//ationoftherange.
Read these instructions completely and carefully.
_] 3-Wire Condu# Installation
Remove tile ._screws li'Oiil tile COIlIlectoF block. Insert bare wires between the
connectoF block tei_rnirl_lls _u-ld movable ntlts. Tighten s(Fews se(urely. I)o not
remove ground strap connection.
WARNING: Connector block is approved for copper wire connection
only. If aluminum wire is used, see note below.
NOTE: ALUMINUM WIRING
I)o not connect aluminum wire to the cormector block.
Use copper buiMing wire rated for the correct amperage and voltage to
make 3 (three) 3" copper jumper wires. Connect wire as per Step 6 or 7
depending on number of'wires,
connector rnanuti_cturer's recommended procedure closely,
Wire used, location and enclosureof splices, etc,, must conform to good wiring practices
and local codes.
_1 _Screw
-_ Connectorblockterminal
I Flexiblecane
Connectorblock
Bracket/_
/ Barewire tips
Loading ...
Loading ...
Loading ...