Loading ...
Loading ...
Loading ...
page 7
IN ORDER TO USE THE HANDHELD REMOTE
CONTROL, PLEASE CONTINUE WITH SECTION 8
for remote control assembly instructions. If you
have already installed the wall control but do not
wish to use the handheld remote control, please
proceed to Section 9.
Gently pull on remote control cover to
separate top and bottom parts. [Refer to
diagram 1.]
In order to use wall control as a handheld
remote control, cut each wire on wall control
(that was not previously used)--use wire
cutters to cut off each wire as close to the wall
control as possible. [Refer to diagram 2.]
Install one 12-volt battery (included) in wall
control. [Refer to diagram 2.]
Attach black faceplate to front of wall control;
press down firmly. [Refer to diagram 3.]
Align holes in wall control with posts located
on inside of TOP part of remote control cover
and press together firmly. Place wall control
into BOTTOM part of remote control cover,
aligning posts in top of remote control cover
with post holes in the bottom. [Refer to
diagram 3.]
(NOTE: Make sure to align narrower ends of
remote control cover before closing.) Squeeze
top and bottom of remote control cover
together until you hear a click at each end,
indicating that the remote control cover has
closed completely.
IMPORTANT: Store the remote control away
from excess heat or humidity. To prevent
damage to remote control, remove the battery
if remote control will not be used for long
periods.
8. Assembly of Handheld Remote Control.
(top)
(bottom)
remote control
cover
wall
control
face-
plate
remote control
cover, BOTTOM
post
hole
diagram 2
post
hole
remote control
cover, TOP
diagram 1
diagram 3
wall control
wire
wire
wire
12V battery
Loading ...
Loading ...
Loading ...