Loading ...
Loading ...
Loading ...
page 4
5. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower hanging
ball and remove stop pin and then slide hanging ball
off of the downrod. [Refer to diagram 1.]
Loosen yoke set screws and nuts at top of motor
assembly. Remove pin and clip from motor housing
yoke. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the downrod.
[Refer to diagram 2.]
Determine the length of threaded downrod you wish
to use. Thread safety cable and electrical wires
through threaded end of downrod and pull extra wire
slack from the upper end of the downrod. [Refer to
diagram 2.]
Thread downrod into the motor assembly yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert pin
and clip that were previously removed. Tighten yoke
set screws and nuts securely. [Refer to diagram 2.]
Locate anti-sway adapter in hardware pack. Slide yoke
cover, canopy cover, anti-sway adapter and canopy
over downrod. (NOTE: Canopy cover must be turned
with shiny side toward the motor assembly. Anti-sway
adapter must be turned with wider end toward the
canopy.) [Refer to diagram 3.]
Thread safety cable and wires through hanging ball
and then slide hanging ball over downrod--the top of
the downrod should be noted as having a set screw
hole; use this hole when setting the set screw. Insert
stop pin into top of downrod and raise hanging ball.
Be sure stop pin aligns with slots on the inside of the
hanging ball. Tighten set screw securely. [Refer to
diagram 4.]
WARNING: Failure to tighten set screw (on hanging
ball) completely could result in the fan becoming
loose and possibly falling.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
hanging ball
stop pin
set screw hole
stop pin
diagram 1
canopy
hanging ball
clip
pin
downrod
electrical wiring
safety cable
yoke set screw
and nut
motor
assembly
downrod
pin
clip
canopy
motor
assembly
yoke set screw
and nut
yoke cover
canopy cover
anti-sway
adapter
diagram 2
diagram 3
diagram 4
Loading ...
Loading ...
Loading ...