Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS
Installation options
Your dryer can be installed one of two ways, either freestanding, or stacked on top of a
Haier front loading washer.
1
Free standing
The dryer stands on the floor and can easily be moved into position.
2
Stacking
Your dryer has been designed to be able to be stacked on top of a Haier
front loading washer.
A stacking kit MUST BE USED between the products and fitted correctly to the washing machine and
1
Move the machine into the desired position. Do not lift the dryer by the top panel.
2
Have a minimum clearance on all sides of at least 20mm.
3
Install the machine on a stable and level floor (if not stacking on top of a front loading washer).
1
Do not install your dryer in such a way that the dryer door
cannot be opened fully.
2
Do not install the dryer outside, in a damp place, where there is a risk of freezing, where
it may be rained on, in direct sunlight or close to a source of heat.
3
Do not place your machine on top of its power cable.
Levelling the machine
It is IMPORTANT to level the machine to ensure the machine runs efficiently with minimal
noise. The dryer should be levelled in as close to its final position as possible so it stands
balanced evenly on all four feet. Ensure the dryer does not rock in any direction.
The dryer comes with four adjustable feet,
wind all four feet up or down until the dryer is
correctly level. A spirit level can assist with this
process. The machine is considered level when
the bubble sits in the centre (ie within the two
lines or the circle), when the spirit level is placed
flat on top of your dryer, in the directions from:
1
left to right,
2
back to front and
3
corner to corner.
Never unscrew the feet completely from their
housings.
Note: after levelling, the corners of the dryer cabinet should be clear of the floor and the
machine must not rock in any direction.
Levelling the feet
dryer, as per the stacking kit instructions.
6
Loading ...
Loading ...
Loading ...