Loading ...
Loading ...
Loading ...
TO LEVEL MOWER HOUSING
Adjust the mower while riding mower is
.parked on level ground or driveway. Make
sure tires are properly inflated (See side
of tire for proper PSI), if tires are over or
underinfiated, you will not properly adjust
your mower,
SIDE-TO-SIDE ADJUSTMENT
• Raise mower to its highest position.
• Measure distance "A" from bottom edge
of mower to ground level at front corners
of mower.
• Toraise the rightside ofthe mower, tighten
lift link adjustment nut.
• Tolower the rightside ofthe mower, !oosen
lift link adjustment nut,
NOTE: Each ful!turn of adjustment nut will
change mower height about 3/16".
BottomEdgeof BottomEdgeof
Mowerto Ground Mowerto Ground
I.t L! ................tl !!ltf,,
• Recheck measurements after adjusting.
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-to
side.
Toobtain the best cutting results, the mower
housing should beadjusted sothatthefront is
approximately 1/8"to 1/2"lower thanthe rear
when the mower is in its highest position,
Check adjustment on right side of riding
mower, Measure distance"F" directly infront
and behind the mandrel at bottom edge of
mower housing as shown.
Nut "G"
Nut "H"
Trunnion
TO REPLACE MOWER BLADE DRWE
BELT
MOWER DRIVE BELT REMOVAL
1. Park ridingmower on a level surface.
2, Set parking brake.
3. Lower mower to its lowest position,
4, Remove mandrel cover from mower
deck.
5. Remove rear engine plate from unit.
6. Remove rear belt keeper from unit,
7. Carefully roll belt over the top of the
mower blade mandrel,
8. Remove belt from idler pulleys.
• To lower front of mower housing turn nuts
"G" and "H" clockwise.
• When distance "F" is 1/8" to 1/2" lower
at front than rear, tighten nut "H" against
trunnion on front link.
• To raise front of mower housing turn nuts
"G" and "H" counter clockwise.
- When distance "F" is 1/8" to 1/2" lower
at front than rear, tighten nut "H" against
trunniononfront link.
NOTE: Each full turn of "G" will change "F"
by approximately about 8/8",
Recheck side-to-side adjustment,
21
9. Check idler pulleystoseethatthey rotate
freely,
10,Remove belt from rear drive pulley.
MOWER DRIVE BELT INSTALLATION
Install in reverse order following instruc-
tions in "MOWER DRIVE BELT REMOVAL"
section.
Loading ...
Loading ...
Loading ...