Loading ...
Loading ...
Loading ...
BLADE REMOVAL
1. Raise mower to highest position to allow
access to blade.
NOTE: Protect your hands with gloves
and/or wrap blade with heavy cloth.
2. Remove blade bolt by turning counter-
clockwise,
3. Install new blade with stamped "THIS
SIDE UP" facing deck and mandrel
assembly.
Mandrel
Assembly
Blade Bolt ._,,_ AL¢_.__Z_f_J/
IMPORTANT: To ensure proper assembly,
center hole in blade must align with star
on mandrel assembly.
4, Install and tighten blade bolt securely
(45-55 Ft. Lbs.).
IMPORTANT: Special blade bolt is heat
treated,
BATTERY
Your riding mower has a battery charging
system which is sufficient for normal use.
. Keep battery and connectors clean.
• Only recharge battery with charger
approved for a 12V 2.8 amp. hour battery.
• Charging with any other charger or an
automotive style charger can cause per-
manent damage to the battery.
• Charge battery for 24 hours for a full
charge,
NOTE: The original equipment battery on
your riding mower is maintenance free. Do
not attempt to open or remove caps or cov-
ers, Adding or checking level of electrolyte
is not necessary,
_kWARNING: Do not jump start battery.
Permanent damage tothe batteryor personal
injury may occur.
TRANSAXLE COOLING
Keep transaxlefree from build-up of dirt and
chaff which can restrict cooling.
V-BELT
Check V-belt fordeterioration and wear after
100 hours ofoperation and replace ifneces-
sary.The belt isnot adjustable. Replace belt
if it begins to slip from wear.
ENGINE
LUBRICATION
Only usehigh quality detergent oil rated with
API service classification SG-SL. Selectthe
oil's SAE viscosity grade according to your
expected operating temperature.
NOTE: Although multi-viscosity oils (5W30,
10W30etc.) improvestarting incoldweather,
theoilswillresultinincreased oilconsumption
when used above 32°F. Check your engine
oil level more frequently to avoid possible
engine damage from running low on oil.
Change the oil after every 25 hours of
operation or at least once a year if the
riding mower is not used for 25 hours in
one year.
Check the crankcase oil level before starting
the engine and after each eight (8) hours
of operation. Tighten oil fill cap/dipstick
securely each time you check the oil level.
TO CHANGE ENGINE OIL
Determine temperature range expected
before oil change. All oil must meet API
service classification SG-SL
• Be sure riding mower is on level sur-
face,
• Oil wilt drain more freely when warm.
• Oil can be pumpedfrom the engine with
a mechanical or electric siphon pump.
1. Remove oil fill cap!dipstick. Be careful
not to allowdirt to enter the engine when
changing oil.
2. Insert end of pump into oil reservoir,
3. Pump oil from reservoir.
Oil Cap
Oil Fill
18
Loading ...
Loading ...
Loading ...