Loading ...
Loading ...
Loading ...
Blaze Outdoor Products Instructional Book
Page | 33
Fuel (Gas) Conversion Instructions for BLAZE Gas Griddles
CAUTION: This should only by performed by a licensed gas professional.
Main Burners:
1.
Remove the griddle plate to expose the main
burners in the appliance. There is a single screw holding
the griddle plate to the housing located below the rear exhaust/flue cover in the middle of the griddle
plate.
2.
On the bottom rear of each burner is a cotter pin. Remove cotter pin. (unless they were removed prior to
installation into an outdoor kitchen)
3.
To remove burner, pull rod upwards and slide burner toward the rear of the appliance. Repeat for each
burner.
4.
Where the burner was previously located, connecting to the main valve through the hole in the basin should
now be empty space.
5.
Inside the space you will find the end of the valve (toward the front of appliance), with an orifice (brass
fitting), screwed into the end of the valve stem.
6.
Carefully remove the orifice with a 6mm socket set and extension. (These are extremely fragile! When
unscrewing, be extremely gentle, for you could easily break the brass fitting and have to replace the valve).
7.
Once the old orifice is removed, replace it with the new orifice, (repeat for all burners). When re-installing
the orifice, do not over tighten or you will strip the brass fitting. Very little pressure is needed!!!
8.
Inspect burners for proper flame appearance. The ideal flame appearance is one that is mostly blue and not
lifting off of the burner surface. There is an air shutter found at the end of the burner (close to the valve)
which can be either opened or closed to make adjustments to the flame's appearance. To adjust, remove
the burner from the appliance and loosen the Philips head screw holding the air shutter to the burner. If the
flame is yellow, open the air shutter to make the flame bluer. If the flame is lifting off of the burner surface,
slightly close the air shutter. Re-tighten the Philips head screw and re-install the burner to recheck the flame
appearance. Repeat if necessary.
Loading ...
Loading ...
Loading ...