Loading ...
Loading ...
Loading ...
Blaze Outdoor Products Instructional Book
Page | 27
Low flame
setting screw
“FLASHBACK” may occur in or around the burner tubes. Flashback exhibits a characteristic
“whooshing/jet like”
sound. If this should occur, immediately turn off your burners, then remove and clean them
with soap, water and a brush until all foreign objects are removed.
Before cooking with your appliance for the first time, burn off any foreign matter and rid the unit of any odors by
burning the main burners only on HIGH for about 10 minutes. When lit, the flame should have a mostly blue
color to
it. It may have a tint of yellow and adjustment to the air shutters can be made to obtain a blue flame and
proper gas
glow (see flame adjustment) . This appliance should be preheated before cooking with the main burner control
settings on
HIGH for five minutes
Flame Adjustment
a. Become familiar with the safety instructions at the front of this manual. Do not smoke while lighting the
appliance or checking the gas supply connections.
b. Make sure that all gas connections are securely tightened and have been leak-tested with a soapy
water solution - never with a flame!
c. With the griddle plate removed, light the main burners and run them on the high
setting.
d. Inspect burners for proper flame appearance. The ideal flame appearance is one that is mostly blue
and
not lifting off of the burner surface. There is an air shutter found at the end of the burner (close to
the valve)
which can be either opened or closed to make adjustments to the flame's appearance. To
adjust, remove
the burner from the appliance and loosen the Philips head screw holding the air shutter
to the burner. If the
flame is yellow, open the air shutter to make the flame bluer. If the flame is lifting off of the burner surface,
slightly close the air shutter. Re-tighten the Philips head screw and re-install the
burner to recheck the flame
appearance. Repeat if necessary.
e. Turn burners to low flame setting and test for proper flame height. Flame should be stable and burning out
of each burner port without danger of going out in the lowest setting.
(To adjust the LOW flame setting simply
light the appliance on the LOW setting and adjust
the screw located under the knob on the front of the valve
using a flat head screwdriver as seen in the
diagram below.)
Loading ...
Loading ...
Loading ...