Loading ...
Loading ...
Loading ...
Before using for the first time en
25
Overview of illumination
modes
You can find an overview of the dif-
ferent illumination modes here.
Illumination mode Status
The LEDs light up
pink.
¡ The device is in the
sprouting phase.
or
¡ Holiday mode is
switched on.
The LEDs light up
white.
One or more height
modules are inserted.
The device is in stand-
ard mode.
The LEDs flash white
twice.
¡ Manual switch
between sleep
mode and stand-
ard mode is con-
firmed.
or
¡ The maximum ca-
pacity of the water
bowl has been
reached.
The LEDs light up
green.
Descaling has started
and the pump is run-
ning.
The LEDs light up or
flash red.
→"Troubleshooting",
Page30
The LEDs do not light
up.
→"Troubleshooting",
Page30
Quantity of nutrient solution
Here you can find an overview for the
status of the nutrient solution.
Illumination mode Status
The LEDs flash white
twice.
The maximum capa-
city of the water bowl
has been reached.
Illumination mode Status
The LEDs light up
blue for 5seconds
while the pump is run-
ning.
Only a little nutrient
solution remains in
the water bowl.
The LEDs flash blue
10 times every
3minutes. The pump
has switched off.
The water bowl con-
tains too little nutrient
solution. Nutrient solu-
tion should be topped
up.
Before using for the first time
Before using for the
first time
Before using for the first time
Prepare the appliance for use.
Preparing the device
1. Remove the light unit.
→Fig.
2
2. Remove all other parts from the
docking unit.
→Fig.
3
3. Clean all parts before using for the
first time.
→"Overview of cleaning",
Page29
4. Put the cleaned and dried parts
out ready for use.
General information
Please bear this information in mind
so that you can get the best out of
your appliance.
Note
Do not install the device under the
following conditions:
¡ in direct sunlight
¡ close to air-conditioning systems
and heaters
¡ outdoors
¡ in areas at risk from frost
¡ in areas with an ambient temperat-
ure exceeding 36°C
Loading ...
Loading ...
Loading ...