Loading ...
Loading ...
Loading ...
INSTALLSEAT
Adjustseatbeforetighteningadjustment
knob.
1. Removeadjustmentknobandflat
washersecuringseattocardboard
packingandsetasideforassemblyof
seattotractor.
2. Pivotseatupwardandremovefrom
thecardboardpacking.Removethe
cardboardpackinganddiscard.
3. Placeseatonseatpanandassemble
shoulderbolt.Tightenshoulderboll
securely.
4. Assembleadjustmentknobandflat
washerloosely.Donottighten.
5. Lowerseatintooperatingpositionand
sitonseat.
6. Slideseatuntilacomfortableposition
isreachedwhichallowsyoutopress
clutch/brakepedalallthewaydown.
7. Getoffseatwithoutmovingits
adjustedposition.
8. Raiseseatandtightenadjustment
knobsecurely.
Seat_
Shoulder SeatPa\ n _._, /
AdjustmentKnob
NOTE: You may now rollor drive your
tractor off the skid. Follow the appropdate
instruction below to remove the tractor
from the skid.
TO ROLLTRACTOR OFF SKID (See
Operatk)n section for location and
function of controls)
1. Press liftlever plunger and raise
attachment liftlever to its highest
position.
2. Release parking brake by depressing
clutch/brake pedal.
3. Place freewheel control in freewheel-
ing position to disengage transmis-
sion (See "TO TRANSPORT" in the
Operation section of this manual),
4. Roll tractor forward off skid.
TO DRIVETRACTOR OFF SKID (See
Operation section for location and
function of controls)
WARNING: Before starting, read,
understand and follow all instructions in
the Operation section of this manual. Be
sure tractor is in a well-ventilated area. Be
sure the area in front of tractor isclear of
other people and objects.
1, Be sure all the above assembly steps
have been completed.
2. Check engine oil level and fill fuel
tank with gasoline.
3. Place freewheel control in "transmis-
sion engaged" position.
4. Sit on seat in operating position,
depress clutch/brake pedal and set
the parking brake.
5. Place motion control lever in neutral
(N) position.
6. Press lift lever plunger and raise
attachment lift lever to its highest
position.
7, Start the engine. After engine has
started, move throttle control to idle
position.
8. Release parking brake.
9. Slowly move the motion control lever
forward and slowly drive tractor off
skid.
10.Apply brake to stop tractor, set parking
brake and place motion control lever
in neutral position.
11.Tum ignition key to =OFF" position,:
Continue with the instructions that follow,
INSTALL MOWER AND DRIVE BELT
Be sure tractor is on level surface and
mower suspension arms are raised with
attachment liftcontrol. Engage parking
brake.
1. Cut and remove ties securing anti-
sway bar and belts. Swing an!i,sway
bar to left side of mower deck.
2. Slide mower under tractor with
deflector shield to fight side of tractor.
IMPORTANT: Check belt for proper
routing in all mower pulley gmove`=_,install
belt into electric clutch pulley groove.
3. install one front link in top hole of the
R.H. front mower bracket and R.H.
front suspension bracket. Retain with
two single loop retainer springs as
shown.
4. install second front link in LH. front
suspension bracket only and retain
with single loop retainer _;pdng as
shown.
Loading ...
Loading ...
Loading ...