Loading ...
Loading ...
Loading ...
_. Connect the other end of the BLACK
cable to good CHASSIS GROUND,
away from fuel tank and battery.
;O REMOVE CABLES, REVERSE ORDER -
I. BLACK cable first from chassis and
then from the fully charged battery.
_.. RED cable last from both battedes.
REPLACING BA'rrERY
• I=CAUTION: Do not short battery
terminals by allowing a wrench or any
other object to contact both terminals at
the same time. Before connecting battery,
remove metal bracelets, wdstwatch
bands, rings, etc.
Positive terminal must be connected first
to prevent sparking from accidental
grounding.
1. Lift hood to raised position.
2. Remove terminal guard.
3. Disconnect BLACK battery cable then'
RED battery cable and carefully
remove battery from tractor.
4. Install new battery with terminals in
same position as old battery.
5. Reinstall terminal guard.
6. First connect RED battery cable to
positive (+) battery'terminal with hex
bolt and keps nut as shown. Tighten
securely.
7. Connect BLACK grounding cable to
negative (-) battery terminal with
remaining hex bolt and keps nut.
Tighten securely
8. Close terminal access doors.
9. Close hood,
Terminal KepsNut _ FlexBolt
Access .... _:, _,_
Terminal __"_ (Red)
Guard_ Cabe
.J
TO REPLACE HEADUGHT BULB
1. Raise hood.
2. Pull bulb holder out of the hole in the
backside of the grill
3. Replace bulb in holder and push bulb
holder securely back into the hole in
the backside of the gdll.
4, Close hood.
INTERLOCKS AND RELAYS
Loose or damaged widng may cause your
tractor to run poorly, stop running, or
prevent itfrom starting.
• Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
TO ADJUST A'rrACHMENT LIFT
SPRING
1. While holding spring bushing with
wrench, loosen jam nut.
• Turn adjustment bolt clockwise to
extend spring and reduce lift effort for
heavier attachments.
• Turn adjustment bolt countemlockwise
for lighter attachments.
2. Retighten jam nut against spdng
bushing.
IMPORTANT: Do not adjust for maximum
spring tension when using light attach-
ments such as a mower. Adjust lift lever
spdng to aid in lifting attachment. Do not
overpower spdng. When removing
attachment, always adjust spdng tension
to its lowest position,
Adjustment Bolt Spring Bushing
LiftSpring
°//
Jam Nut
TO REMOVE HOOD AND GRILL
ASSEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Stand in front of tractor. Grasp hood
at sides, tilt toward engine and liftoff
oftractor.
4. To replace, reverse above procedure.
28
Loading ...
Loading ...
Loading ...