Loading ...
Loading ...
Loading ...
Before you call for service...
PERFORMANCE(cont.) Possible Causes What ToDo
Pilling Result of normal wear on • _._qfile this is not caused b) the washex, )ou can slow the
poly-cotton blends mad pilling process by washing gam/ents inside out.
fuzzy fabrics
Snags,holes,tears,rips Phas, snaps, hooks, sharp • Fasten snaps, hooks, buttons and zippe_.
or excessive wear buttons, belt buckles, • Remoxe loose items like pins, objects in pockets
zippers mad sharp objects and shaI]) buttons.
left in pockets • Turn knits (which snag easil)) inside out.
Undiluted chlorine bleach • Check bleach package instructions fin" proper amotmt.
• Never add madihlted bleach to wash or allow clothes
to come in contnct with m_dihlted bleach.
Chemicals like hair bleach or • Rinse items that may have chemicals on them befin'e
dye, pennmlent wave solution washing.
Wrinkling hnproper sorting • Axoid mixing hear) items (like work clothes) with
light items (like blouses).
• T_' a lid)tic soflenei:
Overloading or incorrect • ix)ad yore" washer so clothes have enough room to
water level move fl'eely with water covering all of the clothes.
Incorrect wash mad • Match Cwle selection to the type of rid)tic you are
dry cycles washing (especially fiw easy care loads).
Repeated washing in • _'_ash in wama or cold watet;
water that is too hot
NOISE Possible Causes What ToDo
Washer is noisy Washer is uneven • To level the ti'ont of the washer, a(!just the fi'ont leveling
legs by rotnting the individual leg in the proper direction
fin" up or down. To level back of washe_; lilt back ot
machine 4" (l 1 cm) and set down,
Washer load is unbalanced • Push the Cycle knob in to stop the washet; open the lid
and redistribute the load evenly: Close the lid and restnrt,
Shipping rod is still assembled • To remo_,e shiplfing rod fi'om washer; pull )ellow tag and
in unit attached rod ti'om the bottom right hand side _ff washe_:
Washer is sitting too close • Pull washer away ti'om the wall; about 4" (l 1 cm)
to wall (causes Maockhag is needed.
during cycle)
OTHER
Labelsontheexterior
ofthewasherwill not
peel offcleanly
Possible Causes
Occasionally the adhesive
used on the labels does
not release clemfly
What ToDo
• Use a hair (ha'er set at the lowest heat setting, directing
the air at the label for a short amotmt of time. This will
release the adhesive easily, without damaging the surfhce
oI the washe_:
/2
Loading ...
Loading ...
Loading ...