Loading ...
Loading ...
Loading ...
*www.novatekco.com * toll free 866.563.7800 * tele 610.363.7800 * fax 610.935.1945 * sal[email protected]*
5
SECTION I
INTRODUCTION
This operation and maintenance manual is furnished with each NOVAIR 700. It outlines the general use and
maintenance requirements for efficient and safe operation.
READ ALL INSTRUCTIONS AND DATA IN THIS OPERATION AND MAINTENANCE MANUAL PRIOR
TO OPERATION OF THIS EQUIPMENT.
These instructions are for your protection and convenience. Please read them carefully. Failure to follow
these precautions could result in injury or death. Whenever using electric powered equipment, basic safety
precautions should be followed.
If after reading this manual you still have questions, contact a NOVATEK authorized distributor or
NOVATEK directly by dialing 1-866-563-7800.
SECTION II
GENERAL DESCRIPTION
The NOVAIR 700 is a portable, electrically powered Air Filtration machine, designed and manufactured by
Novatek Corp. The machines function is to filter air and remove suspended airborne particulates.
This unit has a three stage filtering system. The Pre-Filter (two-ply ring) stage captures the bulk of the dust
and debris. The second Pleated Filter stage captures any dust and dirt able to penetrate the Pre-Filter. The
final stage is the 99.99% - 0.3 micron HEPA Filter utilized in areas where an extremely high level of filtration
is desired.
The NOVAIR 700 requires a 115V - 3 Amp / 230v-2 Amp single phase power source.
WARNING Do not use circuits exceeding specified voltage. Higher voltage will damage controls and
could cause shock or fire hazard.
SECTION III
ROUTINE MAINTENANCE
Inspect the unit for any loose or damaged parts prior to use.
CAUTION: Be sure power supply is in the OFF position prior to inspection!
A. Clean the surfaces of the unit to remove accumulated dust or dirt. Do not use petroleum distillates,
solvents, or thinners as cleaning agents. Remove any accumulated dust and dirt from control panel.
B. Periodic checks should be made of the panel’s Controls to insure proper operation.
C. Filters should be checked hourly/daily and replaced if needed. This will help ensure proper air flow and
extend motor life.
D. Inspect ALL power connection. Be sure that the recessed plug is secure to the panel. If recessed plug
is not secured, electrical shock or shortage may occur.
E. Inspect the power cord connection for breaks, scorching, melting, oxidation, or signs of wear. If cord
shows ANY of these signs, it needs to be replaced.
CAUTION: Do not tamper with or modify the blower housing, control panel, drive motor, or wiring
scheme. Tampering or modifications could result in premature wear or failure and will void factory
warranty.
Loading ...
Loading ...
Loading ...