Loading ...
Loading ...
Loading ...
➢ To remove panels, remove door han-
dle and slide panel out the handle side
of door.
➢ Install panels by sliding panel in
grooves provided by bottom door cap
and side trim.
➢ Replace the handles,
when completed.
7
To avoid personal injury or property
damage, fresh food panel should not
weigh more than 30 lbs (14 kgs) and
freezer panel should not weigh more
than 15 lbs (7 kgs).
WARNING
How to remove and
install panels
(SOME MODELS)
WHAT IF I AM INSTALLING
RAISED PANELS?
If raised panels are used, allow 2
1
⁄2" (A)
minimum clearance between raised edge
of panel and handle.
Please see the recommended dimen-
sions for panelling.
Raised Panel B – 42" x 35
5
⁄8"
(106.7 cm x 90.5 cm)
Raised Panel C – 23
1
⁄4" x 36
1
⁄16"
(59.1 cm x 91.6 cm)
B
C
* Fasteners may require either a T-15 Torx
®
driver or a Phillips screwdriver.
Torx
®
is a registered trademark of Textron Inc.
FREEZER HANDLES
Installing Partial-Width Extruded
Handle
➢ Install handle by
fastening with screws
removed from edge
of door.
• If reversing freezer door, remove
door plugs from top edge of door and
insert into screw holes.
Installing Full-Width/ Trim and Panel
Extruded Handle
➢ Install handle by fas-
tening with screws*
removed from edge of
door.
Removing Partial-Width Extruded
Handle
➢ Remove handle
screws with Phillips
screwdriver.
• Retain screws for
later replacement.
Removing Full-Width/ Trim and Panel
Extruded Handle
➢ Remove handle by
removing three
screws* from handle.
• Retain screws for later replace-
ment.
How to replace the
doors and hinges
1. Install hinge assemblies.
• Install top hinge loosely with
5
⁄16" hex
head screws.
• Install center hinge with Phillips
screws.
• Install bottom hinge with
3
⁄8" hex head
screws.
2. Insert bottom hinge pin
(some models).
• Locate bottom hinge
hole closest to out-
side edge of cabinet, and insert bot-
tom hinge pin. Replace any door
shims, if present.
3. For freezer door
models only: Place
hinge side of freezer
door on bottom hinge
pin and hold freezer door upright while
installing center hinge pin with
5
⁄16" hex
head driver.
• Replace any applicable door shims.
• Make sure the hinge pin is installed
tightly.
For freezer drawer models only:
Install center hinge pin with a
5
⁄16" hex
head driver.
• Replace any applicable door shims.
• Make sure the hinge pin is installed
tightly.
4. Place hinge side of refrigerator door
on center hinge pin.
5. While holding refriger-
ator door upright,
tighten down top hinge
with
5
⁄16" hex head
driver and replace
hinge cover.
A
Loading ...
Loading ...
Loading ...