Loading ...
Loading ...
Loading ...
8
newair.com
ASSEMBLY & INSTALLATION
UNPACKING YOUR FREEZER
• Remove all packaging material. This includes the foam base and all
adhesive tape holding the freezer accessories inside and outside.
• Inspect and remove any remains of packing, tape or printed materials
before powering on the freezer.
ADJUSTING YOUR FREEZER
• Your freezer is designed for freestanding installation only. It should not be
recessed or built-in.
• Place the freezer on a floor strong enough to support It fully loaded.
• When moving the freezer, never tilt it more than a 45-degree angle. This
could damage the compressor and the sealed system.
• If the freezer is tilted let it stand in an upright position for at least 24 hours
prior to plugging. This is to allow the refrigerant to settle.
PROPER AIR CIRCULATION
• To assure your freezer works at the maximum efficiency it was designed
for, you should Install it in a location where there is proper air circulation,
plumbing and electrical connections.
• The following are recommended clearances around the freezer:
• Sides 4" (102mm)
• Back 4" (102mm)
• Top Do not block
Loading ...
Loading ...
Loading ...