Loading ...
Loading ...
Loading ...
page 9
9. Light Kit Assembly. (cont.)
Raise glass shade in order to guide pull
chains through corresponding holes in glass
shade. Align threaded rod on light kit fitter
with hole in middle of glass shade and push
up gently, allowing threaded rod to come
through hole. Replace rubber washer and
flat washer on threaded rod and secure
glass shade with hex nut that was previously
removed.
DO NOT OVERTIGHTEN hex nut as
glass may crack or break.
Thread pull chains through corresponding
holes in finial plate, allowing threaded rod to
come through hole in middle of finial plate,
and push up. Thread center pull chain
through hole in finial and re-attach finial.
DO
NOT OVERTIGHTEN
finial as glass may crack or
break.
threaded rod
light kit fitter
motor
housing
glass
shade
switch housing
finial
finial plate
flat washer
hex nut
rubber washer
fan pull chain
light pull chain
diagram 2 diagram 3 diagram 4
diagram 1
10. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan
speeds with the pull chain on the switch
housing. Start at the OFF position (no blade
movement). First pull will set the fan to HI.
Second pull will set the fan to MEDIUM. Third pull
will set the fan to LOW. Fourth pull will again set
the fan to the OFF setting. If applicable, test light
with the pull chain in the middle. (diagram 1) If
fan and/or light do (does) not function, please
refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off before moving the
reverse switch (located on the switch housing).
Set reverse switch to recirculate air depending
on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely LEFT or completely RIGHT for fan to
function. If the reverse switch is set in the middle
position (diagram 4), fan will not operate.
Attach pull chain extensions supplied or
custom pull chain extensions (sold separately)
to ends of the pull chains
reverse
switch
switch
housing
pull chain
extensions
Loading ...
Loading ...
Loading ...