Loading ...
Loading ...
Loading ...
Programs Additional program settings;
Information
Perm Press
Light Soil
Perm Press
Heavy Soil
Perm Press
Tips
Max.
Load
up to:
Selectable program set- Type of laundry
tings,
default settings (bold)
1/2
load
Temperature Spin speed
Hot High Cotton, linen synthetic or
Warm Med blended fabrics
Cold Low
No spin
SpeedPerfect, Prewash, Extra
Rinse --1, --2
Do not wash new multicolored laundry together with other laundry.
The cycles are time-controlled for lightly soiled fabrics. If fabrics are heavily soiled, reduce the load.
Rinse cycles use cold water only.
Starching
NOTICE: Laundry must not be treated with fabric
softener.
Starching is possible in all wash programs if liquid starch
is used. Measure starch into compartment _ in
accordance with the manufacturer's instructions (clean
first if necessary).
Dyeing/bleaching
Dye should only be used in normal household quantities.
Salt may damage stainless steel. Always follow the dye
manufacturer's instructions.
Do not use the washing machine to bleach clothes.
Soaking
1. Pour soaking agent/detergent into compartment II in
accordance with the manufacturer's instructions.
2. Turn the program selector to Cotton Normal Cold
program.
3. Touch Start/Pause.
4. After approximately, ten minutes, touch Start/Pause.
5. After the required soaking time, touch Start/Pause
again to continue or change the program.
NOTICES
o Load laundry of the same color.
o No additional detergent is required; the soaking
solution is used for washing.
Default Program and Option settings
At the factory, temperature and spin speed options, and
cycle duration ("Finish in" time) are pre-set for all cycles.
After selection of the cycle, these values are displayed in
the display field.
You can change the default settings as follows.
Changing the temperature range
Before and during the cycle, you can change the default
temperature range depending on the cycle progress.
Press the appropriate button until the desired setting is
displayed.
The maximum temperature range that can be set
depends on the cycle selected.
No Spin: This option eliminates the final spin and the
load remains saturated with the final rinse water. The
pump is activated to remove all residual water.
---> Program selection table; Page 25
Finish in
The program end (Finished in) time can be set in one
hour increments to a maximum of 24 h (hours). After
selecting the desired washing program (at the dial) but
before touching the Start button, touch the Finish in
button until the desired time is displayed, e.g. 8 h, then
touch the Start button to start the washer.
NOTICE: The cycle duration is included in the set Finish
in time.
Changing the spin speed range
Before and during the cycle, you can change the spin
speed range depending on the cycle progress.
Touch the appropriate button until the desired setting is
displayed.
Here is an example of a 2hr:30min cycle time and an 8 h
Finish in time.
8 h is displayed (until the Energy-Saving mode activates)
and counts down (approximately 5hr:30min) until the
washing cycle begins (at 2hr:30min) then the cycle
duration 2:30 is displayed and began. Total time
approximately 8 hours.
26
Loading ...
Loading ...
Loading ...