Loading ...
Loading ...
Loading ...
Setting Surface Controls (cont'd)
Setting the Bridge Burner
The Bridge Burner should be used with rectangular shaped cookware. Cookware
like the cast-iron Griddle that is supplied with your cooktop is designed specifically
for best results with the Bridge Burner,
The Bridge Burner feature may be used to combine the cooking power of 2 or if
needed 3 gas surface Burners located along the left-hand side of the glass
cooktop. The left rear and left center Burners are controlled by the left rear
surface Control Knob, In addition the left front Burner may be added to the Bridge
Burner with the left front gas Control Knob (See Figure 1).
Operating the Bridge Burner
1. Push the left rear surface control knob in and turn counterclockwise out of
the OFF position (See Figure 2).
2. Release the knob and rotate to the LITE position (See Figures 2 & 3). Note:
All electronic surface ignitors will spark at the same time. However, only the
selected surface Burner will lite.
3. Visually check that the left rear Burner has lit.
4. Continue to rotate the gas control knob counterclockwise past the first LO
setting to the arrow marked BRIDGE.
5. Visually check that both the left rear and left center Burners are lit.
6. When both burners are lit, continue to turn the control knob
counterclockwise to adjust to the desired flame size for both burners
together. Note: The markings between the 2rid HI and LO settings on the left
rear control knob are for adjusting the flame size for both burners (Refer to
Figure 3).
7. Add the left front Burner if needed. Once lit, visually adjust the flame size of
the left front Burner to match the flame size of the Bridge Burner.
8. Place cooking utensil centered over the left-hand cooktop surface Burner
Grate. DO NOT cook with any of the surface control knobs in the LITE
position (The electronic ignitor will continue to spark if the knob is left in the
LITE position).
Note: If only the left rear surface Burner is needed, follow the instructions provided
below.
Operating only the Left rear Gas Surface Burner
1. Place cooking utensil centered over the left-rear
surface Burner Grate.
2. Push the left rear surface control knob in and turn
counterclockwise out of the OFF position (See
Figure 2).
3. Release the knob and rotate to the LITE position.
Note: All electronic surface ignitors will spark at the
same time. However, only the left rear Burner will
ignite.
4. Visually check that the left-rear burner has lit.
Adjust the flame size by turning the control knob
between the first HI and LO settings (See Figure
3). DO NOT cook with the surface control knob in
the LITE position (The electronic ignitor will
continue to spark if the knob is left in the LITE
position).
OFF
Figure 1
Figure 2
Lo
-Bridge
Burner
flame
adjustment
area
Hi
CD
Bridge Burner
_:_m LITE position
/
," ? t ear ur er
flame adjustment
area
Figure 3
8
Loading ...
Loading ...
Loading ...