Loading ...
Loading ...
Loading ...
Before Setting Surface Controls (cont'd)
Assembly of the Surface Burner Heads, Burner Caps and Burner Grates
It is very important to make sure that all of the Surface Burner Heads, Surface Burner Caps and Surface Burner Grates
are installed correctly and at the correct locations.
1. Be sure to follow the Installation
Instructions when installing your new
cooktop.
2. Remove all packing tape from cooktop.
Remove Burner Caps and Burner
Heads (See Figure 1).
3. Discard all packing material located
under all Burner Heads (if applicable).
4. Place Burner Heads & Caps, match
the letters located under center of
Burner Caps with the letters located
inside Burner Head (only 5K, 9.5K and
16.2K burners are marked with letters
- See Figure 1). Place all Burner
Heads & Caps on the cooktop (See
Figure 1) while carefully aligning the
Electrodes into slots or holes of the
Burner Heads (Figure 3). Note: The
Burner Heads should sit flat on
Cooktop Burner Skirts.
5. Position Bridge Burner Caps. These include one Bridge
Burner Center Cap (rectangular shaped) and the two
Bridge Burner End Caps (The Bridge Burner End Caps
will fit either the front or rear Bridge Burner Head
locations). Make sure that the tabs located under the
Bridge Burner Caps fall into the slots located in the
Bridge Burner Head (See arrows in Figure 2) and that
all the Bridge Burner Caps lie flat and evenly on the
Bridge Burner Head.
6. Unpack Burner Grates. NOTE: Do not force End Burner
Grates down on cooktop. Be careful to line up the 2
Grate Pins located on each of the 2 End Burner Grates
into the Pilot holes located on top of the Burner Caps
(See Figure 4). Position Burner Grates on cooktop and
check that all the Burner Grate legs lie on the glass
surface.
7. Place Center Burner Grate between the end Burner
Grates (36" models only).
30" Cooktop Layout
N
m
36" Cooktop Layout
Example of Burner Assembly
Match letter located
under center of
Burner Cap
with letter
located ,_
BSirdner Burner
Head Cap
_:_ Electrode
Figure 1
Bridge Burner Head
I
Bridge
Burner
End
Cap _Electrode
must be located
Bridge properly in slot of each
Burner Burner Head
Center Figure 3
Cap
....J_/iiiiiiiiiii/
_ i Bridge _GratePin
Burner Burner
End Cap
Cap Pilot Hole
Figure 2 Figure 4
REMEMBER -- DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER
THE GAS ORIFICE HOLDER OPENING. Always keep the Burner Caps and Burner Heads in place whenever the
surface burners are in use.
6
Loading ...
Loading ...
Loading ...