Loading ...
Loading ...
Loading ...
Installation Instructions
MAKE ELECTRICAL CONNECTION TO THE UNIT
[] REMOVE JUNCTION BOX
1 Remo_e the junction box cover 17}removing the
fl'ont two screws,
2 Remove thejmTction box b) removing the top and
bottom rear screws. Note how the tabs on the lower
left side of the junction box ser_v to t7o1(t the skte in
place. This will help when flTe box is being reinstalled.
Unit connector
Junction Junction
boxcover box
[] CONNECT THE CORDSET
Plug the connector, provided in the Direct Connect
ICdt,flfll) into place in the unit mating coililectot'.
Be sure the locking tabs at the sides are engaged.
C0nnector
I NOTE: Order Kit RAK4002C_& to enable a quick
disconnect inside tbejmTction box.
I
[] ATTACH CONDUIT
1 Use the romM knockout at the bottom of the
j mwtion box to attach conduit coming from tim
branch circuit. Remove tim knockout, attach the
conduit and bring wires into the junction box.
I,eave 6" of wire fl'ee at the end ot the conduit
to allow coiTiTectioiTs to be made,
L_ .....
2 If a fuse and flBebolder are to be used, the
knockout at the top of the box is tot motmting
a Buss Fuseboldet: Be sm'e the fuse and fusebolder
are of the same rating as the branch circuit.
I,eadwires at the fuse can be either soldered in
place or attached using UIAisted 1/4" timmle
(receptacle) crimp connectms.
[] REINSTALL JUNCTION BOX
• Reinstall tbe.jmTction box by engaging tim left tabs
on the lower right tace of the unit, aligning the
screw holes at the top and bottom and driving the
two screws tmtil secure. Be sure that all wire leads
are inside the box and not pinched between the box
and the refit. The green insulated ground wire from
the unit MUSTbe comTected to the branch drcuit
grotmd wire.
Make all wire comTections by using al)propriate
UIAisted electrical comTectms and techniques
(black to black, white to white and green to green).
[] REINSTALL JUNCTION BOX COVER
1 Carefully tuck all wires and comTections back inside
thejmTction box. Be sure there are 17o loose
connections or stray tminsulated wires exposed.
2 Place thejunc6on box cover in place. Replace the
two sct'e_vs removed earlier atTd figbtei7 securely.
16
Loading ...
Loading ...
Loading ...