Loading ...
Loading ...
Loading ...
Installation Instructions
REPLACING AN EXISTING UNIT?
Check the "Essential
Elements" label for
importantinformation.
Use the correct wall case
This unit is designed to be installed in a GE plastic or
insulated metal wall case. This minimizes condensation
fl'(nn fimning on the room side of the case.
If the current wall case is not insulated, you can reduce
the possibili_' of condensation fimning by installing
insulation kit I_L_K901 i,, a\:filable where you purchased
the unit.
NOTE: There are several extra holes in the unit side
flanges t0r installation in wall cases other than GE.
To avoid damaging the flange insulation, the installer
should use an awl or other shaq) tool to puncture the
insulation in the appropriate holes beiore installing
the attachment screws.
Use the correct outdoor grille
You should use the outdoor grilles shown on the
"Essential Elements" label on the top of the unit.
• If an existing grille is not replaced, capaci D' and
efficiency will be reduced and the unit tuav tail to
operate properly or tifil prematurely. A deflector kit,
I_L_K40, tua)" be used with grilles that were not
designed t0r your new GE Zonelines. The IL_K40
contains air deflect(ns and gaskets that tuount to the
unit to direct the hot exhaust air away fl'otu the air
intake to allow the unit to fltuction properly. The
grille m tlSt have a 65% minituutu fl'ee area.
• Any vertical deflectors in the existing rear grille should
be retuoved to decrease condenser air recirculation
that can cause the trait to "short-cycle" and lead
to pi'eli/attli'e COlilponent tifihu'e.
Use the correct power cord
I,ocal codes tua)' require the use of arc fault or
leakage current detection devices on 230/208 volt
installations.
Replacing a ducted unit
New ducted installation:
If this unit is to be installed in a new ducted application
using a duct adapter kit, the kit must be installed before
the unit is placed in the wall case. The installation
instructions are packed with the kit.
plate
Existing ducted installation:
Replacement of an existing ducted unit may require
different components. Request this intimnation ti'otu
your sales representative.
• Replacing 230/208 volt turiN:
See page 14.
• Replacing 265 volt turiN:
See pages 15 and 16.
13
Loading ...
Loading ...
Loading ...