GE - General Electric GDP630PGRWW 24 Inch Built-In Fully Integrated Dishwasher

OWNER’S GUIDE - Page 20

For GDP630PGRWW.

PDF File Manual, 72 pages, Read Online | Download pdf file

GDP630PGRWW photo
Loading ...
Loading ...
Loading ...
20
Dishwasher Installation
CONNECT DRAIN LINE
(CONT.)
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT
EXCEED 16’ FROM THE REAR OF THE DISHWASHER
FOR PROPER DRAIN OPERATION.
• Connect drain line to air gap, waste tee or disposer
using the previously determined method. Secure
hose with a hose clamp.
Method 1 – Air gap with waste tee or disposer
Method 2 – “High drain loop” with waste tee or
disposer
With this method you will need the drain hose hanger
set aside earlier.
Fasten drain hose to underside of countertop with the
provided hanger.
IMPORTANT – When connecting drain line to
disposer, check to be sure that drain plug has been
removed. DISHWASHER WILL NOT DRAIN IF PLUG
IS LEFT IN PLACE.
Tip: Avoid unnecessary service call charges for a
no drain complaint.
Make sure excess drain hose has been pulled through
the cabinet opening. This will prevent excess hose
in the dishwasher cavity from becoming kinked or
crushed by the dishwasher.
Remove
Drain
Plug
STEP 15
Hose Clamp
72”
max.
Waste Tee Installation
72”
max.
Disposer Installation
Drain Hose Hanger
18”
min.
32” min. -
72” max.
Waste Tee Installation
Drain Hose Hanger
18”
min.
32” min. -
72” max.
Disposer Installation
CONNECT DRAIN LINE
(CONT.)
The hose should have already been detached from the
tub at locations indicated. NOTE: Do not remove high
drain loop.
• Determine size of inlet port. If required, cut drain hose
connector on the marked line, to fit the inlet port.
If a longer drain hose is required, replace the
provided user bag drain hose with GE Appliances
service part WD24X10065, a 12’ long hose which
can be connected directly to the drain loop already
attached to the unit.
If service part hose is not available, an additional hose
with coupler, ID of 5/8” or 7/8” and no longer than 66”,
may be attached to the provided user bag drain hose.
Secure the connection with hose clamp (obtain locally)
to the provided user bag drain hose.
STEP 15
1”
5/8”
IMPORTANT: Do not cut
corrugated portion of hose.
Cutting Line
Hose Clamp Coupler Hose Clamp
Detach only the sections of the drain hose shown in white.
Do NOT detach the sections of the drain hose shown in gray.
Loading ...
Loading ...
Loading ...