Loading ...
Loading ...
Loading ...
EN-8
EN
Air Cooler
SFN 9011SL
2015
11/2015
3. SETTING AUTOMATIC GRILLE ROTATION
3.1 To activate automatic grille rotation, press the SWING button C5. The front grille A1 will turn
clockwise, and the display will show the symbol C8.
3.2 To turn off automatic grille rotation, press the SWING button C5 again. Symbol C8 on the
display goes off.
4. AIR HUMIDIFYING/COOLING FUNCTION
4.1 Remove the water tank Aqs and fi ll it with clean, cold water. After fi lling the tank, if you want
to humidify and cool the air at the same time, add one coolant pack B2. The coolant pack B2
removes heat from the water and thus keeps it cooler for several hours. Slide the tank Aqs back
into the lower part of the fan and secure it by turning the button Aqd . After the button is turned,
a tongue slides out that secures the tank Aqs against movement.
Caution:
Capacity of the water tank is 6 litres. Do not fi ll the tank above the maximum water level
indicator.
Before using the coolant pack B2, keep it in a freezer for several hours.
4.2 Activate the humidifying/cooling function by pressing button C2. For 3 minutes, the fan speed
is controlled automatically. Then the fan speed switches to the one you have set. If you have not
set a speed, the fan automatically switches to high speed.
4.3 The humidifying/cooling function automatically deactivates within 10 seconds after the water
tank empties. To refi ll the water tank, repeat the steps 4.1 and 4.2.
5. SETTING THE AUTOMATIC SHUT-OFF TIMER
5.1 The TIMER button C4 is intended for setting the automatic shut-off time within a range of 0.5 to
7.5 hours.
5.2 Each time the TIMER button C4 is pressed, the shut-off time lengthens by 0.5 hour. The set time
will appear on the display. Every 30 minutes the remaining time until shut-off is updated on the
display. After the set time is reached the fan shuts off.
6. TURNING OFF
The OFF button C6 is intended for turning off the fan.
7. USING THE REMOTE CONTROL
The remote control buttons have the same functions as those on the control panel. To use the
remote control, point it at approximately the level of the LED display. The maximum signal range
is 6 m.
Note:
If there are obstructions between the remote control and the LED display, the signal may not
go through.
Loading ...
Loading ...