Loading ...
Loading ...
Loading ...
PAGE 17
CARING FOR THE DISHWASHER The control panel of the dishwasher can be cleaned using a slightly dampened
cloth. After cleaning, ensure it is dryed thoroughly.
To clean the internal edge of the door, you should only use a soft, damp cloth
with warm water. Avoid using any spray cleaners as these can penetrate into
the door lock and electrical components.
CLEANING THE SPRAY ARMS It is necessary to clean the spray arms regularly for hard water chemicals will
clog the spray arm jets and bearings.
To remove the upper spray arm, hold the nut and rotate the arm clockwise to
remove.
To remove the lower spray arm, pull the spray arm upwards (as per the
diagram below).
Wash the arms in warm soapy water and use a brush to clean the jets. Replace
the spray arms after rinsing thoroughly.
GENERAL CARE INSTRUCTIONS FOR YOUR DISHWASHER
After every wash, leave the door slightly open so that moisture and odours
are not trapped inside.
Before performing maintenance or cleaning, always switch off at the power
outlet and remove the plug.
To clean the exterior and rubber door seals of the dishwasher, never use
solvents or abrasive cleaning products. Warm soapy water should always
be sufficient, or for stubborn stains only use specialty cleaning products
specifically made for dishwashers.
When your dishwasher won't be used for a long period of time, it is
recommended that you run a wash cycle with the dishwasher empty and then
leave the dishwasher door slightly open. Also unplug the dishwasher from the
power socket.
When moving the appliance, always try to ensure it is kept in the vertical
position. If absolutely necessary, it can be positioned on it's back.
One of the factors that can cause odours to form is residual food that remains
trapped in the seals. Periodic cleaning with a soft damp cloth (as described
above) will prevent this from occuring.
Loading ...
Loading ...
Loading ...