Loading ...
Loading ...
Loading ...
E BRUSH SERVICING
Electrical Shock Or Personal Injury Hazard
Disconnect electrical supply before servicing or
cleaning the unit. Failure to do so can result in
electrical shock or personal injury from cleaner
suddenly starting.
TO CHECK BRUSH:
Base Support Bars
• When brushes
are worn to the
level of the base
support bars,
replace the
brushes.
TO REPLACEBRUSH:
1. Remove POWER-MATETM cover, belt and brush
assembly. (See ""Toremove belt" in "BELTCHANGING
AND BRUSHCLEANING" on page 13.)
2. Remove brush supports, washers, screws, end
brush, brush sprocket pieces from ends of brush
assembly.
3.Push outworn
brushes.Ifthe
beater bar is
chipped or
gouged,
replaceit.
4.Slidenew
beater bar and
brushesintoslots.
NOTE:New
brushes and
beater bar may
be easier to
install ifthey are
soaked in warm
water for a few
minutes. Dry
thoroughly
before installing.
5. Reassemble brush assembly. To line up screw holes
in dowel, sprocket and end brush, be sure beater bar
portion of end brush lines up with beater bar on
brush dowel.
6. Replace belt, brush assembly, POWER-MATETM
cover, light bulb and light cover. (See "To replace
belt" in "BELTCHANGING AND BRUSHCLEANING" on
page 13.)
BRUSH ASSEMBLY
_W Brush
Sprocket
(-_ _ Flange Brush
"_i/_-_-_, , _-,,. _ Sprocket
/'_L " _ EndBrush
asher J_PT"r_._ /F
Brushes
Washer Brush
15
Loading ...
Loading ...