Loading ...
Loading ...
Loading ...
Problem Possible Cause Solution
Machine Power cord not plugged in. PIugin power cord.
Stops No power at plug. Check electrical source or call
electrician.
Fuse blown or circuit Replace fuse or reset circuit breaker.
breaker open. If problem continues, call electrician.
Using an extension cord, Do not use extension cords.
Timer is not lined up. Turntimer to the rightslightly
and pullto start.
Timer knob not pulled out, Set and pull out knob.
Washerat pause in Allow cycle to continue
PERMANENT PRESS IICycle (see "Operation YourWasher").
(approximatelytwo minutes).
Machine is overloaded. Wash smaller loads.
Agitator Not The top of the agitator moves This is normal.
Working only in one direction.
The top of the agitator is loose. This is normal.
Water Level The topof the agitator is much This is normal.
Too Low/Not higher than the highest water
Completely level.This creates a perception
Filling of the washer not being full.
Tub is Tub pulled forward when Ensuretub is centered before
Crooked unloading, starting washer.
Tub moves. This is normal.
Unit not level. Ensurefront feet are installed and
nuts aretightened. Level washer.
Reset rear legs (see "Installation
Instructions," Section G).
Lint on Load Improper sorting. Sort lint givers from lint takers
and by color.
Overloading. Lint can be trapped in load if
overloaded. Wash smaller loads.
Paper or tissue in pockets. Clean out pockets before washing.
Not enough detergent. Use enough detergent to
hold lint in water.
Detergent not dissolving. UseAutomatic TemperatureControl
Watertemperatures lower (ATC).ATC ensureswash water
than 70°F (21°C). temperature will be warmer than
70°F (21°C).
39
Loading ...
Loading ...
Loading ...