Loading ...
Loading ...
Loading ...
WARNING Exhaust heat/gases could ignite
combustibles, structures or damage fuel
tank causing a fire, resulting in death or
serious injury.
Contact with muffler area could cause burns resulting in
serious injury.
, DO NOTtouch hot parts and AVOID hot exhaust gases.
Allow equipment to cool before touching.
Keepat least 5 feet (1.5 m) of clearance on ail sides of pressure
washer including overhead.
it is a violation of California PuNic Resource Code, Section
4442, to use or operate the engine on any forest-covered,
brush-covered, or grass-covered land unless the exhaust
system is equipped with a spark arrester, as defined in Section
4442, maintained in effective working order. Other states or
federal jurisdictions may have similar laws.
Contact the original equipment manufacturer, retailer, or dealer
to obtain a spark arrester designed for the exhaust system
installed on this engine.
Replacement parts must be the same and installed in the same
position as the original parts.
New t{) Step Y{)ur Pressure Washer
1. Releasespray gun trigger and let engine idle for two
minutes.
2. Move throttle control lever on engine to "Slaw" 41-
position, then "Step" (_} position.
3. ALWAYS point spray gun in a safe direction, press red
button and squeezespray gun trigger to release
retained high water pressure.
A WARNING The high pressure streamof water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation,
Spray gun traps high water pressure, even when engine us
stopped and water is disconnected, which could result i
serious injury.
Keephighpressurehoseconnectedto pumpandspraygun
whilesystemis pressurized.
ALWAYSpointspraygun in safedirection,pressredbutton
andsqueezesprayguntriggerto releasehighpressure,every
timeyou stop engine.
New to Use Spray Tips
The quick-connect on the nozzle extension allows you to
switch between five different quick connect spray tips. Spray
tips can be changed while pressure washer is running once
spray gun trigger is locked. The spray tips vary the spray
pattern as shown.
Fallow these instructionsto change spray tips:
1. Pull back collar on quick-connect and pull current
spray tip off. Store spray tips in holder provided on the
handle.
A WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
. NEVERexchangespraytipswithoutthetriggerlockbeing
engagedonthe spraygun.
* DONOTtwist spraytips whilespraying.
2. Select desired spray tip:
° For delicate rinse (lower pressure and higher flow),
for gentle cleaning of cars/trucks, boats, RV's, patio
furniture, lawn equipment, etc, select white 40° or
green 25° spray tip.
* For general rinsing (medium pressure and medium
flow), idealfor most all purpose cleaning such as
home siding, brick patios, wood decks, driveways
and sidewalks, garage floors, etc, select yellow
15° spray tip.
* For maximum rinsing (higher pressure and lower
flow), for stubborn or hard to reach surface such as
second story surfaces, paint removal, oil stains,
rust removal or other stubborn substances (tar,
gum, grease, wax, etc.), select red 0° spray tip.
* To apply detergent, applies project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black detergent spray tip.
3. Pull back on collar, insert new spray tip and release
collar. Tug on spray tip to make sure it is securely in
place.
LOwPressure
Useto apply
detergent
Black White
40°
Green Yellow
25° 15°
Red
0o
14 BRIGGSandSTRATTON.CONI
Loading ...
Loading ...
Loading ...