Loading ...
Loading ...
Loading ...
About the automatic icemoker
A newly installed refrigerator may take 12 to 24 hours to begin making ice.
Automatic Icemoker
On dispenser models,
to access ice or reach
the power switch:
o Lift the bin, then pull it
forward until the bin stops.
The icemakerwill produce seven cubes
per cycle-approximately 100-130cubes
in a 24-hour period,depending on freezer
compartment temperature, room
temperature, number of door openings
and other useconditions.
If the refrigerator is operated before the
water connection ismade to the icemaker,
setthe power switch in the O(off) position.
When the refrigerator has been connected to
the water supply, set the power switch to the
I (on)position.
Theicemakerwillfillwith water when it cools
to 15°F(-10°C).A newly installedrefrigerator
may take 12to 24hoursto begin making ice
cubes.
Youwill hear a buzzing soundeach time
the icemaker fillswith water:
Throw awag the first few batches of ice
Lower the bin to access ice
or reach the power switch.
NOTE: In order to take full
advantage of the tilt-out ice bin,
onlg store items on the shelf below
the ice bin that are no toiler than
the lowest point on the bin.
Special note about dispenser models:
_ Dispenser models have a tilt-out ice bin.
The bin can be tilted out as shown in
the illustrations, and it will hold itself up
while gou take ice out or turn the icemaker
power switch on and off Be sure to put the
bin back in place before closing the door:
_ To restore your ice level from an empty
bucket stage, the following steps ore
recommended:
O 12 hours after the first batch of ice
has fallen into the bin, dispense
3 to 4 cubes.
O After an additional 5 hours, dispense
3 to 4 cubes again.
These stepswill restore gour ice level
in the shortest amount of time.
to allow the water line to clear: _ Icemaker
Besure nothing interferes with the sweep _ ,,
ofthe feelerarm.
When the bin fills to the levelof thefeeler
arm, the icemaker will stop producing ice.
It isnormal for several cubes to bejoined _i
together: Green J _,_---_
If iceis not usedfrequently, old icecubes will powerLight FeelerArm
become cloudg,taste stale and shrink. NOTE:Inhomes with lower-than-overage
water pressure,you may hearthe icemoker
chiclemultiple timeswhen making one botch
of ice.
o Lift the bin, then pull it
forward until the bin stops.
Removing Ice Bin (dispenser models)
CAUTION:The ice bin is heavy when full.
Set the power switch to the O(off) position
before removing the bin.
When replacing the bin, be sure to press
it firmly into place. Ifit does not go all the
wag back, remove it and rotate the drive
mechanism 1/4 turn. Then push the bin
back again.
Dispenser Models only
O Lift andpull forward again
to remove the bin.
14
Loading ...
Loading ...
Loading ...