Loading ...
Loading ...
Loading ...
22 HOWTO USE
Wafer Filter Reset _
When the water filter indicator turns on, you
need to replace the water filter. After replacing
the water filter, press and hold the Water Filter
button for three seconds to turn the indicator
light off. You need to replace the water filter ap-
proximately every six months.
rhA
Lock C_
• The Lock button deactivates the controls
and dispenser functions. When power is
initially connected to the refrigerator, the
Lock function is off.
• If you ,want to activate the Lock function
to lock other buttons, press and hold the
Lock button for three seconds or more.
The Lock icon will display and the Lock
function is now enabled.
• When the Lock function is activated, no
other buttons will work. The dispenser
pad is also deactivated.
• To disable the Lock function, press and
hold the Lock button for approximately
three seconds.
Display Off Mode
The display lights up and stays lit for 60 seconds
when the refrigerator is initially plugged in. All
the display lights will then go off except the lock
and dispenser icon selected (crushed, water
or cubed), and the display only lights ,when the
door is opened or a display button is pressed.
The display will remain off until a door is opened
or a button is pressed. Once on, the display will
remain on for 20 seconds.
Demo Mode (For Store Use Only)
The Demo Mode disables all cooling in the
refrigerator and freezer sections to conserve
energy while on display in a retail store.
To deactivate:
With either refrigerator door opened, press and
hold the Refrigerator and Ice Plus buttons at
the same time for five seconds. The control
panel ,will beep and the temperature settings
will display to confirm that Demo Mode is deac-
tivated. Use the same procedure to activate the
Demo Mode.
Adjusting Confro! Settings
Give the refrigerator time to cool down com-
pletely before making final adjustments. It is
best to wait 24 hours to let the normal settings
(recommended in the Temperature section) sta-
bilize before making any changes. If you need
to adjust the temperature in the refrigerator or
freezer, start by adjusting the refrigerator tem-
perature and allow 24 hours for the temperature
to stabilize again. If it is still too warm or too
cold, then adjust the freezer control.
Use the settings listed in the chart below as
a guide. Always remember to wait at least 24
hours between adjustments
CONDITION/REASON
REFRIGERATORsectiontoo
warm.
• Door openedoften.
Largeamountof food added.
Roomtemperatureverywarm.
FREEZERsection too warm/ice
not madefast enough.
Dooropenedoften.
Largeamountof food added.
• Verycold (55°F(13°C))room
temperature.(Compressor
doesnot cycle often enough.)
Heavyice usage.
• Air vents blocked by items.
REFRIGERATORsectiontoo
cold.
Controls not setcorrectlyfor
yourconditions.
FREEZERsection too c01d.
• Controls not setcorrectlyfor
yourconditions.
RECOMMENDEDADJUSTMEKrr
Setthe REFRIGERATORcontrol
one degreecolder;wait 24 hours
for the new settingto take full
effect beforemakinganother
adiustment.
Set the FREEZERcontrol one
degreecolder; wait 24 hours
for the new setting to takefull
effect before makinganother
adjustment.
Move items out of air stream.
Setthe REFRIGERATORcontrol
onedegreewarmer;wait24
hoursfor thenew settingto take
full effect beforemakinganother
adiustment.
Set the FREEZERcontrol one
degreewarmer; wait 24 hours
for the new setting to takefull
effect before makinganother
adjustment.
Loading ...
Loading ...
Loading ...