Loading ...
Loading ...
Loading ...
Surface
Cooking
FEATURE OVERVIEW
• Ceramic-GlassCooktop
OFF
Expandable Radiant Element
Control Dial
EXPANDABLERADIANT HEATING UNITS (some models)
This heating unit adapts to both small and large heating utensils. The unit control dial has a dual
set of graduations. Forsmall utensils usethe left side of the control dial; for large utensils the
right. Only the inner surface of the unit heats when using it for small utensils; the whole surface
heats for large utensils. The hot surface and surface indicator lights will glow when the heating
unit isturned ON.
Note: During any heat setting of the outer radiant element, the inner radiant element cycleson
and off with the outer element.
Indicator Lights
Two different surface control lights will glow on your range: Surface Indicator Lights and Hot
Surface Indicator Lights.
• The surface indicator lights, located on the control panel, glow when any surface unit is
turned on. A quick glance at the lights after cooking isan easy check to be sure all surface
controls are turned off,
• The hot surface indicators lights, located under the glass cooktop, will come on asthe
surface cooking area heats up and will continue to glow until the glass cooktop hascooled
down to a moderate level. The lights may remain on even though the controls are turned to
OFF.
Oven Vent(s)
and Racks
Oven Vent(s) and Racks
OvenVent
Location
Oven Vent Location
The oven isvented at the rear of the cooktop or through the
right rear coil element. When the oven ison, warm air is
released through the vent(s). This venting is necessary for
proper air circulation in the oven and good baking results. DO
NOT block the vent(s). Doing so may cause cooking failures,
fire or damage to the appliance.
Arranging Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THEOVEN ISCOOL (PRIORTO OPERATINGTHE
OVEN). Always use oven mitts when using the oven.
To remove an even rack, pull the rack forward until it stops. Lift up front of rack and slide out.
To replace an oven rack, fit the rack onto the guides on the oven walls. Tilt the front of the
rack upward and slide the rack back into place.
Changing Oven
Light
Be sure the oven is unplugged and all parts are COOL before replacing the oven
light bulb. Do not turn the oven light on during a self-cleaning cycle. High temperature will
reduce lamp life.
On some models an interior oven light will turn on automatically when the oven isopened.
The oven light may be turned on when the door isclosed by using the oven light switch located
on the Electronic Oven control.
On a self-cleanning oven the lamp iscovered with a glass shield held in place by a wire holder.
THIS GLASSSHIELDMUST ALWAYS BE IN PLACEWHEN THE OVEN IS IN USE.
To Replace the Light Bulb:
BESUREOVEN ISCOOL
1. Turn the power off at the main source,
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 Watt appliance bulb only.
4. Forself-cleaning oven, presswire holder to one side to release glass shield, change bulb and
be sure to replace glass shield.
12
Loading ...
Loading ...
Loading ...