Loading ...
Loading ...
Loading ...
ADJUSTMENT/REPAIR
FRICTION WHEEL ADJUSTMENT
1. Remove bottom panels (Figure 35).
2. Position gear select lever in 1st forward gear.
3. Note position of friction wheel on disc drive plate. Proper
position from the right outer side of disc drive plate to the
centre of friction wheel must be 3" (76 mm) (see
Figure 36).
If an adjustment is required, proceed as follows:
1. Remove washer and cotter pin connecting trunnion nut
to speed rod (Figure 37).
\
Remove Bolts
Loosen Bolts_
Figure 35
2. Twist trunnion nut up or down on shift rod to obtain the
correct friction wheel position.
3. Put end of trunnion nut through hole in speed control rod
and reattach washer and cotter pin.
4. Reinstall bottom panels.
Disc Drive Plate
< 3" •
(76mm)
Figure 36
r/
CotterPin
Speed Control Rod
Speed Rod F_
Figure 37
F-001005J 28
Loading ...
Loading ...
Loading ...