Loading ...
Loading ...
o DRESS PROPERLY - Do not
wear loose clothing or jewelry
They can be caught in moving
parts. Use of rubber gloves and
substantial footwear is recom-
mended when working outdoors
Wear protective hair covering to
contain long hair.
o DON'T OVERREACH - Maintain
proper footing and balance at all
times
o USE SAFETY GLASSES- Al-
ways wear proper eye protection,
and use face or dust mask if op-
eration is dusty.
o MAINTAIN UNIT WITH CARE-
Keep cutting edges clean for best
performance and to reduce the
risk of injury.. Follow instructions
for lubricating and service Keep
handle dry, clean, and free from
oil and grease+
+ AVOID UNINTENTIONAL
STARTING - Don't carry unit with
a finger on the switch.
° CHECK DAMAGED PARTS-
if the clipper or blade pack experi-
ences a hard impact, check that
no parts were damaged and verify
that the unit operates properly
Check for misalignment or bend-
ing of moving parts, breakage of
parts, and any other condition that
may affect operation. A part that is
damaged should be properly re-
paired or replaced by an author-
ized service center.
+ STAY ALERT -Watch what you
are doing. Use common sense.
Do not operate the too! when you
are tired.
° DON'T GRASP THE EXPOSED
CUTTING BLADES or cutting
edges when picking up or holding
the unit. Do not attempt to remove
cut material nor hold material to
be cut when blades are moving
Make sure the unit's switch is off
when clearing jammed material
from blades.
To reduce risk when using charger:
+ DO NOT use charger outdoors or in
wet conditions; use inside only,
• DO NOT charge the unit when the
temperature is below +40 F or
above +120 F
o This unit and its charger are des-
igned to work together,, DO NOT
charge the combo clipper with any
other charger and DO NOT use this
charger with any other appliance
o The charger is designed to operate
on 120 volts, DO NOT attempt to
use it at any other voltage,,
SAVE THESE INSTRUCTIONS
o CHARGE BATTERY PRIORTO
USE - The Combo Clipper does
not come fully charged when pur-
chased. So before using the unit,
the battery must be charged, Be-
fore charging the batter€, read
safety and charging instructions
o PROPER RUNTIME AND PER-
FOMANCE can only be obtained
with a fully charged battery
o CHARGE TIME-20 hours of
charging is sufficient to replenish
the battery to a full charge Initial
use, long periods of inactivity, or
storage at extreme temperatures
may require extended charge time
+ WALL CHARGE BRACKET-
Before charging the unit, make
sure the charge bracket is securely
attached to the wall; attach with
screws to a walt stud, or use ap-
propriate wall anchors.
To Charge Battery:
1.. Plug the charger into a 120 Volt AC
outlet,
2. Place the Combo Clipper into the
wall charge bracket.
3 The Combo Clipper is now in
charge+
4. Charge for at least 20 hours..
Charging Notes:
o CAUTION: The charger can be
used with 60Hz cycle, and 1I5-120
VAC electricity only
Loading ...
Loading ...
Loading ...