Loading ...
Loading ...
Loading ...
Water
Determine where you will connect the dishwasher to the hot water supply. Review Figure 8 on page 7 and note
the location of the water valve. Incoming water temperature should be approximately 140°F (60°C). Water
temperature limits are 120°F minimum and 160°F maximum (49°C - 71 °C).
The dishwasher water inlet valve has a %" National Pipe Thread female fitting. Determine how much copper
tubing will be required. Copper tubing must have a minimum outside diameter of 3/e". High-pressure rated
plastic tubing with a minimum inner diameter of 1/4"may be used where local plumbing codes permit.
It is recommended that a shut-off valve be installed outside the dishwasher cabinet. Water pressure should be
between 20 and 120 PSI (pound per square inch).
Cut the water access hole in the shaded area as shown in Figure 1 on page 4. Complete the plumbing rough-in
before putting the dishwasher into place.
Note: The furnished drain hose must not be used as a water supply line. Do not use a rubber garden
hose for water supply line. Either one of these hoses will burst.
Electrical Power Supply
The dishwasher operates on a 120VAC 60Hz fused electrical supply. Provide a separate circuit with a fuse or
circuit breaker rated for at least 15 amps, 20 amps if connected with disposer, but not more than 20 amps.
J
Fire Hazard
Do not use an extension cord.
Failure to do so can result in death,
or electrical shock.
Electrical Shock Hazard
Electrically ground dishwasher.
Connect grounding wire to
green grounding nut In
terminal box.
Failure to do so can result In
death or electrical shock.
Grounding Instructions
This appliance must be connected to a grounded metal fixture or to a permanent wiring system, or an equip-
ment grounding conductor must be run with the circuit conductors and connected to the equipment grounding
terminal or lead on the appliance. Do not connect the dishwasher to the electrical supply until the appliance is
permanently grounded. Grounding must be in accordance with the National Electrical Code and local codes
and ordinances.
Note: This unit is provided with stranded copper wire with coating to prevent corrosion. Connect with
copper wire only.
Determine where you will connect to the electrical supply. Note the location of the electrical junction box in
Figure 8 on page 7. Cut the access hole in the shaded area shown in Figure 1 on page 4. Pull electrical cable
through into the cabinet area through the access hole.
After the dishwasher has been positioned inside the cabinet, the electrical connections can be made.
9
Loading ...
Loading ...
Loading ...