Loading ...
Loading ...
Loading ...
• If you connect to a sink drain, using the "Y" Branch Tailpiece and Connector Kit No. 19353 will make this
connection easier. The kit includes all of the necessary fittings and complete installation instructions.
• If you connect to a disposer, use the larger end of the corrugated hose which has been designed to fit the
disposer without any special connectors (see inset of Figure 9).
NOTE: Be sure to remove the knockout plug from inside the disposer inlet fitting before attaching the
drain hose.
If the drain hose is to be routed through the floor to a separate trap, the trap must be vented to prevent
siphoning. To provide proper venting, install the Air Gap Kit (stock no. 19355 [plastic], or stock no. 19356
[copper with rubber connector]) into the countertop. Route the drain hose up to the inlet side of the air gap.
Continue drain line from outlet side of air gap down through floor to separate trap (see Figure 10).
Do not cut the corrugated drain hose. Pull excess hose through cabinet and place under sink. Make sure the
hose does not come into contact with any sharp edges.
Connecting to a Sink Drain
f
Cut here
for 3/4"
connection.
Cuthere
for 5/8'
connection.
IL
1 1/4"
Dishwasher
Pump
Connection
J
2" DrainHose Hole
Connecting to a Disposer
2" DrainHoseHole
8
Figure 9
Figure 10
Loading ...
Loading ...
Loading ...