toggle
bolt
FL-6ES
08/10
1. Release the screws and
starwashers. Push the sockets in
place according to the wiring
diagram on the fixture.
2. Reattach the wire cover.
3. Secure the two open screw
eyehooks (provided) to the ceiling
42 1/2" apart. Secure directly to a
joist or using toggle bolts (not
included). See diagram A.
4. Attach the mounting chains
(provided) to the open screw eye
hooks.
5. Attach the mounting chains
into the dual slots that are located
on top of the fixture housing.
Crimp the screw eye hooks closed
using pliers.
6. Level the fixture by adjusting
the length of the chain at the
open screw eye hooks. Crimp the
screw eye hooks closed using
pliers.
7. Install proper bulb type and
wattage (not included). Insert the
pins on both ends of the
fluorescent tube into the lamp
holders on both ends. Rotate the
tube until a slight "click" is felt.
Repeat for additional bulbs.
8. Plug cord into a grounded
120V, 60 Hz outlet.
9. When the ballast is replaced,
reverse the process from step 8 and 2.
Loosen the screw and nut to remove
the ballast and sockets from fixture.
After that repeat the normal process
from step 2 and 8.
Joist
Diagram A
FLUORESCENT
LIGHTING
Imported By: CANARM LTD., 2157 Parkedale Ave., Brockville, Ontario, K6V 5V6, Tel: (613) 342-5424, Fax: (613) 342-8437
INSTALLATION:
QUESTIONS OR CONCERNS CONTACT CANARM AT:
1-800-265-1833 (English) / 1-800-567-2513 (French) / Monday through Friday 8:00 AM to 5:00 PM E.S.T.
TOOLS AND MATERIALS REQUIRED:
SAFETY PRECAUTIONS:
Blade
Screwdriver
Wiring supplies
as required by
electrical code
Pliers
Hammer
Wood Screw
Toggle Bolt
L
I
G
H
T
I
N
G
&
F
A
N
S
E
C
L
A
I
R
A
G
E
S
&
V
E
N
T
I
L
A
T
E
U
R
S
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A
PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS
INVOLVED.
3. THIS FIXTURE IS DESIGNED FOR 120 VOLT CIRCUIT. IF UNSURE ABOUT WIRING, CONSULT AN ELECTRICIAN.
WARNING: DO NOT CONNECT FIXTURE TO DIMMER CIRCUIT.
4. USE ONLY ENERGY STAR APPROVED BALLAST (WITH LAMP SOCKETS) MANUFACTURED BY CSA FILE
NUMBER 226237 AND MARKETED BY CANARM LIMITED. THIS BALLAST IS REPLACEABLE BY A
QUALIFIED ELECTRICIAN WITHOUT CUTTING OF THE WIRES.
