Loading ...
Loading ...
Loading ...
www,GEAppliancesocom
(con)PERFDRMANCE::=' I PossibleCauses WhatToDo
Pilling Result of normal wear on =_q_ile fl_isis not caused by flaewashe_, you can slow d_e
poly-cotton blends and pilling pr'ocess by washing garments inside out.
fuzzy fabrics
Snags,holes,tears,rips Pins, snaps, hook% sharp * Fasten snaps, hooks, buttons, and zippel_
or excessivewear buttons, belt bucldes, = Remove loose items like pins, objects in pockets and
zippers, and sharp objecls shaq) buttons.
left in pockets
• Turn "knits (which snag e_.siiy)inside out.
Undiluted chlorine bleach
Chemicals like hair' bleach
or dye, permanent wave
solution
Wrinkling Improper sorting
, Check bleach pacI_lge insu'ucfions for proper mnount,
* Never add tmdiluted bleach to wash or allow clod_es to
come in contact _dda undiluted bleach
*Rinse items flint may have chemicals on fl_em before
washing.
* Avoid mLxing heavy items (like work clodaes) _th light
items (like blouses),
. Try a fabric softener.
Overloading or' ° Load your washer so clothes have enough room to
incorrect water level move fieely
Incorrect wash and ° Match Cycle selection to dae t)])e of fabric you are
dry cycles washing (especially fot easy care loads)
Repeated _aslaing in ° Wash in wan-n or cold watel:
water that is too hot
NOISE I:: : PossibleCauses WhatToDo
Washerisnoisy _rasher is uneven ° To level the front: of d_e washer; acIjust d_e front leveling
legs by rotating d_e indi_4dual leg in d_e proper _firection
for tip or' down To level back of washe_; lift back, of
machine 4" (11 cm) and set clown
Washer load is * Press PAUSE to stop die washeL open fl_e lid and
unbalanced redistribute dae toad evenly Close the lid and press
START,
Slfipping rod is still assembled ° "lb lemove shipping rod from washer; pull yellow tag and
in unit attached rod from die bottom right hand side of w_her:
Washer is sitting too close t Pull washer away from d_e wall; about 4" (11 cm)
to wall (causes knocking iSneeded.
duringcyde)
Labelsontheexterior
ofthewasherwil/not
peel offclean!y i
PossibleCauses
Occasionally the adhesive
used on the labels does
not release cleanly
WhatToDo
o Use a hair dryer set at die lowest heat setting, directing
dae air' at dae label ibr a short amount of time, This wilt
release O_eadhesive easil); wiflaout darna#ng die surface
of d_e washer_
15
Loading ...
Loading ...
Loading ...